Search results
Results from the WOW.Com Content Network
When converting oil density to specific gravity using the above definition, it is important to use the correct density of water, according to the standard conditions used when the measurement was made. The official density of water at 60 °F according to the 2008 edition of ASTM D1250 is 999.016 kg/m 3. [2] The 1980 value is 999.012 kg/m 3. [3]
In the oil industry, mud weight is the density of the drilling fluid and is normally measured in pounds per gallon (lb/gal) (ppg) or pound cubic feet (pcf) . [1] In the field it is measured using a mud scale or mud balance. Mud can weigh up to 22 or 23 ppg. A gallon of water typically weighs 8.33 pounds (or 7.48 ppg).
The specific weight, also known as the unit weight (symbol γ, the Greek letter gamma), is a volume-specific quantity defined as the weight W divided by the volume V of a material: = / Equivalently, it may also be formulated as the product of density, ρ, and gravity acceleration, g: = Its unit of measurement in the International System of Units (SI) is newton per cubic metre (N/m 3), with ...
For example, in the brewing industry, the Plato table lists sucrose concentration by weight against true SG, and was originally (20 °C/4 °C) [7] i.e. based on measurements of the density of sucrose solutions made at laboratory temperature (20 °C) but referenced to the density of water at 4 °C which is very close to the temperature at which ...
Water density calculator Archived July 13, 2011, at the Wayback Machine Water density for a given salinity and temperature. Liquid density calculator Select a liquid from the list and calculate density as a function of temperature. Gas density calculator Calculate density of a gas for as a function of temperature and pressure.
Oil companies typically measure density in pounds per gallon (ppg) or kilograms per cubic meter (kg/m 3) and pressure measurement in pounds per square inch (psi) or bar or pascal (Pa). Pressure increases with fluid density. To find out the amount of pressure fluid of a known density exerts per unit length, the pressure gradient is used. The ...
Since this is a measurement of mass, any conversion to barrels of oil equivalent depends on the density of the oil in question, as well as the energy content. Typically 1 tonne of oil has a volume of 1.08 to 1.19 cubic metres (6.8 to 7.5 bbl).
The Symons pan or tank is a standard instrument of the UK Met Office. It is a steel container 1.83 m (6 ft) on a side and 0.61 m (2 ft) deep, sunk into the ground with an above-ground rim of 7.6–10 centimetres (3.0–3.9 in) and is painted black internally. Its evaporation rate is lower than the Class A pan and conversion factors must be used.