Search results
Results from the WOW.Com Content Network
In earlier days, birch bark was occasionally used as a flashing material. [7] Most flashing materials today are metal, plastic, rubber, or impregnated paper. [8]Metal flashing materials include lead, aluminium, copper, [1] stainless steel, zinc alloy, other architectural metals or a metal with a coating such as galvanized steel, lead-coated copper, anodized aluminium, terne-coated copper ...
1 Lead Flashing. 5 comments Toggle Lead Flashing subsection. 1.1 Lead contamination. 1.2 Lead flashing pics. 2 How is flashing made? 1 comment. Toggle the table of ...
Reglet detail. A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the ...
Language links are at the top of the page across from the title.
AOL latest headlines, entertainment, sports, articles for business, health and world news.
The lead wire is a coated copper wire, a tinned copper wire or another electrically conductive wire used to connect two locations electrically. In electronics, a lead (/ ˈ l iː d /) or pin is an electrical connector consisting of a length of wire or a metal pad (surface-mount technology) that is designed to connect two locations electrically.
A typical CRT contains several kilograms of lead as lead oxide in the glass [101] depending on its size; 12 inch CRTs contain 0.5 kg of lead in total while 32 inch CRTs contain up to 3 kg. [6] Strontium oxide began being used in CRTs, its major application, in the 1970s. [153] [154] Before this, CRTs used lead on the faceplate. [155]
Through-hole (leaded) resistors. In electronics, through-hole technology (also spelled "thru-hole") is a manufacturing scheme in which leads on the components are inserted through holes drilled in printed circuit boards (PCB) and soldered to pads on the opposite side, either by manual assembly (hand placement) or by the use of automated insertion mount machines.