Search results
Results from the WOW.Com Content Network
As such, push-rod suspension systems allow for much greater high-speed stability, much lower levels of body-roll, and a much lower centre of gravity for the vehicle. [7] For pull-rod suspension systems, the only difference is the orientation of the rocker arms. In a push-rod system, the rocker arms are placed at the highest point in the assembly.
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
Watt's linkage automobile suspension Watt's linkage train suspension. Watt's linkage is used in the rear axle of some car suspensions as an improvement over the Panhard rod, which was designed in the early twentieth century. Both methods are intended to prevent relative sideways motion between the axle and body of the car.
Added brief section on push/pull rods, though this is my first proper edit, so feel free to edit further etc. or give recommendations for the future! This new section could also use a diagram of some kind. thanks, ARDawson ( talk ) 12:36, 6 April 2011 (UTC) [ reply ]
A Panhard rod (also called Panhard bar, track bar, or track rod) is a suspension link that provides lateral location of the axle. [1] Originally invented by the Panhard automobile company of France in the early twentieth century, this device has been widely used ever since.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
Moving rods or cables are attached to the outer ends of the L. When one is pulled, the L rotates around the pivot point, pulling on the other rod. A typical 180-degree bellcrank consists of a straight bar that pivots at or near its center. When one rod is pulled or pushed, the bar rotates around the pivot point, pulling or pushing on the other rod.
A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing ) on one end to the wheel carrier or axle , on the other to the chassis or unibody of the vehicle.