Search results
Results from the WOW.Com Content Network
The Intel 8085 ("eighty-eighty-five") is an 8-bit microprocessor produced by Intel and introduced in March 1976. [2] It is the last 8-bit microprocessor developed by Intel. It is software-binary compatible with the more-famous Intel 8080 with only two minor instructions added to support its added interrupt and serial input/output features.
The 8259 may be configured to work with an 8080/8085 or an 8086/8088. On the 8086/8088, the interrupt controller will provide an interrupt number on the data bus when an interrupt occurs. The interrupt cycle of the 8080/8085 will issue three bytes on the data bus (corresponding to a CALL instruction in the 8080/8085 instruction set).
The SDK-85 MCS-85 System Design Kit was a single board microcomputer system kit using the Intel 8085 processor, clocked at 3 MHz with a 1.3 μs instruction cycle time. It contained all components required to complete construction of the kit, including LED display, keyboard, resistors, caps, crystal, and miscellaneous hardware.
The 8255 is a member of the MCS-85 family of chips, designed by Intel for use with their 8085 and 8086 microprocessors and their descendants. [1] It was first available in a 40-pin DIP and later a 44-pin PLCC packages. [2] It found wide applicability in digital processing systems and was later cloned by other manufacturers.
30-pin SIMM, 256 KB capacity Two 30-pin SIMM slots on an IBM PS/2 Model 50 motherboard. Standard sizes: 256 KB, 1 MB, 4 MB, 16 MB. 30-pin SIMMs have 12 address lines, which can provide a total of 24 address bits. With an 8-bit data width, this leads to an absolute maximum capacity of 16 MB for both parity and non-parity modules (the additional redundancy-bit chip usually doe
This file contains additional information, probably added from the digital camera or scanner used to create or digitize it. If the file has been modified from its original state, some details may not fully reflect the modified file.
Block diagram of Intel 8253. The timer has three counters, numbered 0 to 2. [7] Each channel can be programmed to operate in one of six modes. Once programmed, the channels operate independently. [1] Each counter has two input pins – "CLK" (clock input) and "GATE" – and one pin, "OUT", for data
jmp start;data v_divisor: ds 1; v_dividend: ds 1; v_rest: ds 1; v_result: ds 1;;code;function to_divide_the party performs division by parts adding 1 to each "division" para_dividir_parte: nop;saves the return address pop d;;takes the parameters in BC pop b;;throws the dividend in A mov a, b; cmp c; compares if the divisor is no bigger than the dividend jc end_division;a the division is made ...