Search results
Results from the WOW.Com Content Network
An octave band is a frequency band that spans one octave (Play ⓘ).In this context an octave can be a factor of 2 [1] [full citation needed] or a factor of 10 0.301. [2] [full citation needed] [3] [full citation needed] An octave of 1200 cents in musical pitch (a logarithmic unit) corresponds to a frequency ratio of 2 / 1 ≈ 10 0.301.
For example, the frequency one octave above 40 Hz is 80 Hz. The term is derived from the Western musical scale where an octave is a doubling in frequency. [note 1] Specification in terms of octaves is therefore common in audio electronics. Along with the decade, it is a unit used to describe frequency bands or frequency ratios. [1] [2]
Radar-frequency bands according to IEEE standard [17] Band designation Frequency range Explanation of meaning of letters; HF: 0.003 to 0.03 GHz: High frequency [18] VHF: 0.03 to 0.3 GHz: Very high frequency [18] UHF: 0.3 to 1 GHz: Ultra-high frequency [18] L: 1 to 2 GHz: Long wave S: 2 to 4 GHz: Short wave C: 4 to 8 GHz: Compromise between S ...
Tone control is a type of equalization used to make specific pitches or frequencies in an audio signal softer or louder. It allows a listener to adjust the tone of the sound produced by an audio system to their liking, for example to compensate for inadequate bass response of loudspeakers or earphones, tonal qualities of the room, or hearing impairment.
In stretched tuning, two notes an octave apart, whose fundamental frequencies theoretically have an exact 2:1 ratio, are tuned slightly farther apart (a stretched octave). If the frequency ratios of octaves are greater than a factor of 2, the tuning is stretched; if smaller than a factor of 2, it is compressed." [3]
Roll-off of a first-order low-pass filter is 20 dB/decade (≈6 dB/octave) A simple first-order network such as a RC circuit will have a roll-off of 20 dB/decade. This is a little over 6 dB/octave and is the more usual description given for this roll-off.
In music, 72 equal temperament, called twelfth-tone, 72 TET, 72 EDO, or 72 ET, is the tempered scale derived by dividing the octave into twelfth-tones, or in other words 72 equal steps (equal frequency ratios).
The frequencies displayed on the audiogram are octaves, which represent a doubling in frequency (e.g., 250 Hz, 500 Hz, 1000 Hz, wtc). Commonly tested "inter-octave" frequenices (e.g., 3000 Hz) may also be displayed. The intensities displayed on the audiogram appear as linear 10 dBHL steps.