Search results
Results from the WOW.Com Content Network
The word rheostat was coined in 1843 by Sir Charles Wheatstone, [7] from the Greek ῥέος rheos meaning "stream", and - στάτης-states (from ἱστάναι histanai, "to set, to cause to stand") meaning "setter, regulating device", [8] [9] [10] which is a two-terminal variable resistor. For low-power applications (less than about 1 ...
A liquid rheostat or water rheostat [1] or salt water rheostat is a type of variable resistor. This may be used as a dummy load or as a starting resistor for large slip ring motors. In the simplest form it consists of a tank containing brine or other electrolyte solution, in which electrodes are submerged to create an electrical load .
A potentiometer being calibrated and then measuring an unknown voltage. R 1 is the resistance of the entire resistance wire. The arrow head represents the moving wiper.. In this circuit, the ends of a uniform resistance wire R 1 are connected to a regulated DC supply V S for use as a voltage divider.
The L pad attenuates the signal by having two separate rheostats connected in an "L" configuration (hence the name). One rheostat is connected in series with the loudspeaker and, as the resistance of this rheostat increases, less power is coupled into the loudspeaker and the loudness of sound produced by the loudspeaker decreases.
Created Date: 8/30/2012 4:52:52 PM
Liquid earthing resistor, 33 kV, 21 ohms, rated for 750 amps for 10 seconds, providing an earth path for the tertiary winding of a 275/132/33kV autotransformer.
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...