Search results
Results from the WOW.Com Content Network
Multicast is the most common approach, and each VXLAN network identifier (VNI) is mapped to a single multicast group, while each multicast group may map to one or more VNIs. When a VTEP comes alive it uses the Internet Group Management Protocol to join the multicast groups for the VNIs it uses. When a VTEP has to send BUM traffic it will send ...
Multicast address scope IPv6 address [note 1] IPv4 equivalent [19]: §8 Scope [28] Purpose ffx0::/16, ffxf::/16: Reserved ffx1::/16: Interface-local Packets with this destination address may not be sent over any network link, but must remain within the current node; this is the multicast equivalent of the unicast loopback address. ffx2::/16: ...
In computer networking, multicast is a type of group communication where data transmission is addressed to a group of destination computers simultaneously. [1] Multicast can be one-to-many or many-to-many distribution. [2] [3] Multicast differs from physical layer point-to-multipoint communication.
The Internet Group Management Protocol (IGMP) is a communications protocol used by hosts and adjacent routers on IPv4 networks to establish multicast group memberships. IGMP is an integral part of IP multicast and allows the network to direct multicast transmissions only to hosts that have requested them.
[2] [3] [4] Regarding IP multicast, it is a technique for one-to-many communication over an IP network. IP multicast covers some part of common multicast routing protocol. IP multicast also describe IP multicast software (i.e. VideoLAN,qpimd – PIM Daemon for Quagga, GNU — PIM module for the Quagga Routing Suite, UFTP, etc.).
Ethernet nodes implement unicast by ignoring packets not directly addressed to them. A wireless network is naturally multicast – all devices within a reception radius of a transmitter can receive its packets. Wireless nodes ignore packets addressed to other devices, but require forwarding to reach nodes outside their reception radius.
Multiprotocol Extensions for BGP (MBGP or MP-BGP), sometimes referred to as Multiprotocol BGP or Multicast BGP and defined in IETF RFC 4760, [1] is an extension to Border Gateway Protocol (BGP) that allows different types of addresses (known as address families) to be distributed in parallel.
In computer networking, unicast is a one-to-one transmission from one point in the network to another point; that is, one sender and one receiver, each identified by a network address. [ 1 ] Unicast is in contrast to multicast and broadcast which are one-to-many transmissions.