Search results
Results from the WOW.Com Content Network
In 3D computer graphics, a wire-frame model (also spelled wireframe model) is a visual representation of a three-dimensional (3D) physical object. It is based on a polygon mesh or a volumetric mesh, created by specifying each edge of the physical object where two mathematically continuous smooth surfaces meet, or by connecting an object's constituent vertices using (straight) lines or curves.
Blocking may also provide spacers or attachment points between adjoining stud walls, for example, where an interior and exterior wall meets, or at a corner where techniques such as the "three-stud corner with blocking" are used. [2]
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
An interior or exterior corner, with an angle or type of bevel, is called a "chamfer". Fillet geometry, when on an interior corner is a line of concave function , whereas a fillet on an exterior corner is a line of convex function (in these cases, fillets are typically referred to as rounds).
The PMI annotation is created on the 3D CAD model, associated to edges and faces, and can be exported into neutral formats such as ISO 10303 STEP and 3D PDF. This information can then be used by a number of down-stream processes. PMI can be used to generate annotation on a traditional 2D drawing the data.
A 2D CAD drawing A 3D CAD model Computer-aided design ( CAD ) is the use of computers (or workstations ) to aid in the creation, modification, analysis, or optimization of a design . [ 1 ] : 3 This software is used to increase the productivity of the designer, improve the quality of design, improve communications through documentation, and to ...
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
The drainage system collects any water entering the basement and drains it to an internally placed sump pump system, which will then pump the water out of the basement. The Federal Emergency Management Agency (FEMA) recommends basement waterproofing with a water alarm and "battery-operated backup pump" as a preventive measure against the high ...