Search results
Results from the WOW.Com Content Network
The red curve is an epicycloid traced as the small circle (radius r = 1) rolls around the outside of the large circle (radius R = 3).. In geometry, an epicycloid (also called hypercycloid) [1] is a plane curve produced by tracing the path of a chosen point on the circumference of a circle—called an epicycle—which rolls without slipping around a fixed circle.
The biconical antenna has a broad bandwidth because it is an example of a traveling wave structure; the analysis for a theoretical infinite antenna resembles that of a transmission line. For an infinite antenna, the characteristic impedance at the point of connection is a function of the cone angle only and is independent of the frequency.
The second antenna is a reference antenna, which points rigidly at the first antenna. Each antenna is alternately connected to a transmitter having a particular source impedance, and a receiver having the same input impedance (the impedance may differ between the two antennas).
The rhombic antenna is a directional wire antenna used on MF and HF bands for shortwave reception. The antenna consists of a wire suspended above the ground in the shape of a rhombus , terminated at one end by a resistor equal the the wire's characteristic impedance, about 400 to 600 ohms, and at the other end connected to the feedline to the ...
For most antennas the boresight is the axis of symmetry of the antenna. For example, for axial-fed dish antennas, the antenna boresight is the axis of symmetry of the parabolic dish, and the antenna radiation pattern (the main lobe) is symmetrical about the boresight axis. Most antennas boresight axis is fixed by their shape and cannot be changed.
A turnstile antenna, or crossed-dipole antenna, [1] is a radio antenna consisting of a set of two identical dipole antennas mounted at right angles to each other and fed in phase quadrature; the two currents applied to the dipoles are 90° out of phase. [2] [3] The name reflects the notion the antenna looks like a turnstile when mounted ...
A reference antenna is an antenna with known performance. It is normally used to calibrate other systems. It is normally used to calibrate other systems. During a relative calibration, an antenna's phase center offset (PCO) and phase center variations (PCV) are computed with respect to the reference antenna which is normally assigned zero PCV ...
This produced the Antenna Modeling Program, or AMP, which was extensively modified to support disk-based files, simplify the input and output to make it easier to use, and extensively documented. A follow-up, AMP2, added calculations for extended surfaces like reflectors.