Search results
Results from the WOW.Com Content Network
The Christie M1931 originated as the M1928, which used Christie's suspension, and had the ability to run on its tracks or the wheels.The M1928 was demonstrated unofficially to the US Army by traversing a route at an average speed of 45 km/h (28 mph); by contrast the US Army's T1E1 tanks – expected to replace their WWI-era M1917 light tanks – averaged 16 km/h (9.9 mph) over the same route.
The US Tank Corps ordered a single tank from Christie's company based on this design. The tank, known as the M1919, was delivered in early 1921 and tested until Christie proposed modifying it. The modifications added coil suspension to the front wheels and removed the turret - the armament being moved to the nose of the vehicle.
Pages in category "Tank suspensions" The following 6 pages are in this category, out of 6 total. This list may not reflect recent changes. C. Christie suspension; H.
Torsion bar suspension inside Leopard 2 Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end ...
The success of the BT series, when observed by Fuller at Russian Army maneuvers influenced the British to buy a Christie M1931 tank, imported as a "Tractor", which led to Christie's suspension incorporated into British cruiser tank designs such as the A13 Cruiser Mk IV, Crusader, and others.
The M.1921 had added suspension and the turret was removed and the guns placed within the hull instead, but it was also rejected on the grounds of being unreliable and under-powered. [1] Tests of the M.1921 continued until July 1924 [2] Going up and down 45º and 35º slopes. AD1116719-020 M1919 Christie tank
The vertical volute spring suspension system is a type of vehicle suspension system which uses volute springs to compensate for surface irregularities. This type of the suspension system was mainly fitted on US and Italian tanks and armored fighting vehicles starting from throughout the 1930s up until after the end of the Second World War in 1945.
The 10TP was listed as the intended equipment for four tank battalions within new motorised units. Assembly of the first 10TP prototype began in 1937 at the Experimental Workshop (WD) of the State Engineering Plants (PZInż.) Factory in Ursus, near Warsaw. This factory served as the central production site for Polish tanks during 1931-1939.