enow.com Web Search

  1. Ads

    related to: working of a diode in parallel

Search results

  1. Results from the WOW.Com Content Network
  2. Diode - Wikipedia

    en.wikipedia.org/wiki/Diode

    A diode is a two-terminal ... These have a low work ... When an LED-like structure is contained in a resonant cavity formed by polishing the parallel end ...

  3. Transient-voltage-suppression diode - Wikipedia

    en.wikipedia.org/wiki/Transient-voltage...

    A bidirectional transient-voltage-suppression diode can be represented by two mutually opposing avalanche diodes in series with one another and connected in parallel with the circuit to be protected. While this representation is schematically accurate, physically the devices are now manufactured as a single component.

  4. Antiparallel (electronics) - Wikipedia

    en.wikipedia.org/wiki/Antiparallel_(electronics)

    However, during an ESD event across the domains, one would want a path for the high current to traverse. Without the antiparallel diodes in place, the voltage induced by the ESD event may result in the current following an unknown path that often leads to damage of the device. With the diodes in place the current can travel in either direction.

  5. Zener diode - Wikipedia

    en.wikipedia.org/wiki/Zener_diode

    The two types of diode are in fact constructed in similar ways and both effects are present in diodes of this type. In silicon diodes up to about 5.6 volts, the Zener effect is the predominant effect and shows a marked negative temperature coefficient. Above 5.6 volts, the avalanche effect dominates and exhibits a positive temperature coefficient.

  6. Clamper (electronics) - Wikipedia

    en.wikipedia.org/wiki/Clamper_(electronics)

    The negative swing of the output will not dip below about −0.6 V, assuming a silicon PN diode. [ 1 ] A clamper (or clamping circuit or clamp ) is an electronic circuit that fixes either the positive or the negative peak excursions of a signal to a defined voltage by adding a variable positive or negative DC voltage to it. [ 2 ]

  7. Bridge circuit - Wikipedia

    en.wikipedia.org/wiki/Bridge_circuit

    In power supply design, a bridge circuit or bridge rectifier is an arrangement of diodes or similar devices used to rectify an electric current, i.e. to convert it from an unknown or alternating polarity to a direct current of known polarity. In some motor controllers, an H-bridge is used to control the direction the motor turns.

  8. Diode logic - Wikipedia

    en.wikipedia.org/wiki/Diode_logic

    The following diode logic gates work in both active-high or active-low logic, however the logical function they implement is different depending on what voltage level is considered active. Switching between active-high and active-low is commonly used to achieve a more efficient logic design.

  9. Flyback diode - Wikipedia

    en.wikipedia.org/wiki/Flyback_diode

    In Figure 2, a flyback diode was added in antiparallel with the solenoid. Instead of spiking to -300 V, the flyback diode only allows approximately -1.4 V of potential to be built up (-1.4 V is a combination of the forward bias of the 1N4007 diode (1.1 V) and the foot of wiring separating the diode and the solenoid [dubious – discuss]). The ...

  1. Ads

    related to: working of a diode in parallel