enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Check valve - Wikipedia

   en.wikipedia.org/wiki/Check_valve

   Tilting-disc inconel check valve Check valve symbol on piping and instrumentation diagrams. The arrow shows the flow direction. Vertical lift check valve. A check valve, non-return valve, reflux valve, retention valve, foot valve, or one-way valve is a valve that normally allows fluid (liquid or gas) to flow through it in only one direction. [1]

3. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   All DWV systems require various sized fittings and pipes which are measured by their internal diameter of both the pipes and the fittings which, and in most cases are Schedule 40 PVC wye's, tee's, elbows ranging from 90 degrees to 22.5 degrees for both inside diameter fitment (street) as well as outer diameter fitment (hub), repair and slip ...

4. List of valves - Wikipedia

   en.wikipedia.org/wiki/List_of_valves

   Valves can be categorized also based on their function: Check valve or non-return valve, allows the fluid to pass in one direction only; Flow control valve, to maintain and control a variable flow rate through the valve; Poppet valve, commonly used in piston engines to regulate the fuel mixture intake and exhaust; Pressure-balanced valve

5. Atmospheric vacuum breaker - Wikipedia

   en.wikipedia.org/wiki/Atmospheric_vacuum_breaker

   It is usually constructed of brass and resembles a 90-degree elbow with a hood on its top to allow air to enter the water system if a siphon attempts to form. Inside this elbow is a poppet valve that is held "up" by the water pressure found in the system, closing the air entrance to the device. If the pressure in the "upstream side" is reduced ...

6. Valve - Wikipedia

   en.wikipedia.org/wiki/Valve

   Schematic 3 way ball valve: L-shaped ball right, T-shaped left. Valves with three ports serve many different functions. A few of the possibilities are listed here. Three-way ball valves come with T- or L-shaped fluid passageways inside the rotor. The T valve might be used to permit connection of one inlet to either or both outlets or connection ...

7. Pilot-operated relief valve - Wikipedia

   en.wikipedia.org/wiki/Pilot-operated_relief_valve

   The downstream side is the pipe or open air where the PORV directs its exhaust. The outlet pipe is typically larger than the inlet. 2 in × 3 in (51 mm × 76 mm), 3 in × 4 in (76 mm × 102 mm), 4 in × 6 in (100 mm × 150 mm), 6 in × 8 in (150 mm × 200 mm), 8 in × 10 in (200 mm × 250 mm) are some common sizes.