Search results
Results from the WOW.Com Content Network
This is the simplest arrangement of masonry units. If the wall is two wythes thick, one header is used to bind the two wythes together. [3] Header course: This is a course made up of a row of headers. [1] Bond course: This is a course of headers that bond the facing masonry to the backing masonry. [1] Plinth: The bottom course of a wall.
Flattening is a measure of the compression of a circle or sphere along a diameter to form an ellipse or an ellipsoid of revolution respectively. Other terms used are ellipticity , or oblateness . The usual notation for flattening is f {\displaystyle f} and its definition in terms of the semi-axes a {\displaystyle a} and b {\displaystyle b} of ...
A slurry wall is a civil engineering technique used to build reinforced concrete walls in areas of soft earth close to open water, or with a high groundwater table. [1] This technique is typically used to build diaphragm (water-blocking) walls surrounding tunnels and open cuts, and to lay foundations .
A water table is a projection of lower masonry on the outside of a wall, slightly above the ground, or at the top of a wainscot section of a wall (in this case also known as a sill). It is both a functional and architectural feature that consists of a projection that deflects water running down the face of a building away from lower courses or ...
A leaf is as thick as the width of one brick, but a wall is said to be one brick thick if it as wide as the length of a brick. Accordingly, a single-leaf wall is a half brick thickness; a wall with the simplest possible masonry transverse bond [definition needed] is said to be one brick thick, and so on. [21]
In some areas, such as South Wales, there is a tradition of placing the coping stones on a final layer of flat stones slightly wider than the top of the wall proper (coverbands). In addition to gates, a wall may contain smaller purposely built gaps for the passage or control of wildlife and livestock such as sheep. The smaller holes usually no ...
World War I: British diagram for the construction of revetted trenches - the revetment here is the part forward of the standing soldier. According to the U.S. National Park Service, and referring mostly to their employment in the American Civil War, a revetment is defined as a "retaining wall constructed to support the interior slope of a parapet.
The keystone is the centre stone or masonry unit at the apex of an arch. The springer is the lowest voussoir on each side, located where the curve of the arch springs from the vertical support or abutment of the wall or pier. [1] The keystone is often decorated or enlarged.