Search results
Results from the WOW.Com Content Network
The Delco ignition system, also known as the Kettering ignition system, points and condenser ignition or breaker point ignition, is a type of inductive discharge ignition system invented by Charles F. Kettering. It was first sold commercially on the 1912 Cadillac [1] and was manufactured by Delco.
The contact breaker is operated by an engine-driven cam.On an engine with a distributor, the contact breaker can be found beneath the distributor cap.The position of the contact breaker is set so that it opens (and hence generates a spark) at exactly the optimum moment to ignite the fuel/air mixture.
A predecessor system called "Unitized Ignition" was optional on 1972 and 1973 Pontiacs. [citation needed] Most—but not all—HEI systems have the ignition coil mounted in the distributor cap. A control module and magnetic pickup are mounted in the distributor, in place of a conventional ignition system's breaker points and condenser.
The torque, or rotational power that prevents the ignition switch from changing modes, was required by GM's own standards to be between 10 N·cm and 20 N·cm (Newton centimeters). However, it was less than 10 N·cm, a force so little that made it prone to changes in modes which could potentially shut off the engine. [11]
The discharge capacitor within the CD ignition had the ability to provide a powerful spark in excess of 4 times the spark power of the Kettering system using the same coil, with the exception that spark energy could be maintained at high rpm unlike the Kettering system. The Hyland unit consumed only four amperes at 5000rpm (8cyl) or 10,000rpm ...
Articles relating to ignition systems, which generate a spark or heat an electrode to a high temperature to ignite a fuel-air mixture. Subcategories This category has only the following subcategory.
The most famous aftermarket electronic ignition which debuted in 1965, was the Delta Mark 10 capacitive discharge ignition, which was sold assembled or as a kit. The Fiat Dino was the first production car to come standard with EI in 1968, followed by the Jaguar XJ Series 1 [9] in 1971, Chrysler (after a 1971 trial) in 1973 and by Ford and GM in ...
Cooling is required to remove excessive heat—high temperature can cause engine failure, usually from wear (due to high-temperature-induced failure of lubrication), cracking or warping. Two most common forms of engine cooling are air-cooled and water-cooled. Most modern automotive engines are both water and air-cooled, as the water/liquid ...