Search results
Results from the WOW.Com Content Network
In thermodynamics, superheating (sometimes referred to as boiling retardation, or boiling delay) is the phenomenon in which a liquid is heated to a temperature higher than its boiling point, without boiling. This is a so-called metastable state or metastate, where boiling might occur at any time, induced by external or internal effects.
The most critical element of reboiler design is the selection of the proper type of reboiler for a specific service. Most reboilers are of the shell and tube heat exchanger type and normally steam is used as the heat source in such reboilers. However, other heat transfer fluids like hot oil or Dowtherm (TM) may
Boiling is the method of cooking food in boiling water or other water-based liquids such as stock or milk. [13] Simmering is gentle boiling, while in poaching the cooking liquid moves but scarcely bubbles. [14] The boiling point of water is typically considered to be 100 °C (212 °F; 373 K), especially at sea level.
The energy required to heat water is significantly lower than that needed to vaporize it, for example for steam distillation [10] and the energy is easier to recycle using heat exchangers. The energy requirements can be calculated from steam tables. For example, to heat water from 25 °C to steam at 250 °C at 1 atm requires 2869 kJ/kg.
Primary producers (e.g. plants, cyanobacteria) are affected by warm water because higher water temperature increases plant growth rates, resulting in a shorter lifespan and species overpopulation. The increased temperature can also change the balance of microbial growth, including the rate of algae blooms which reduce dissolved oxygen ...
The heat source is inside a furnace or firebox that has to be kept permanently surrounded by the water in order to maintain the temperature of the heating surface below the boiling point. The furnace can be situated at one end of a fire-tube which lengthens the path of the hot gases, thus augmenting the heating surface which can be further ...
The essential service water system (ESWS) circulates the water that cools the plant's heat exchangers and other components before dissipating the heat into the environment. Because this includes cooling the systems that remove decay heat from both the primary system and the spent fuel rod cooling ponds, the ESWS is a safety-critical system. [7]
The Reactor Protection System (RPS) is a system, computerized in later BWR models, that is designed to automatically, rapidly, and completely shut down and make safe the Nuclear Steam Supply System (NSSS – the reactor pressure vessel, pumps, and water/steam piping within the containment) if some event occurs that could result in the reactor entering an unsafe operating condition.