enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Gypsum recycling - Wikipedia

    en.wikipedia.org/wiki/Gypsum_recycling

    Gypsum waste from new construction activities is typically a clean waste, and primarily consists of off-cuts of plasterboard (drywall, wallboard or gyprock) when the boards have been cut to fit the dimensions of the wall or ceiling. The waste may constitute 15% of the gypsum materials used on the site.

  3. Drywall - Wikipedia

    en.wikipedia.org/wiki/Drywall

    Various sized cuts of 1 ⁄ 2 in (13 mm) drywall with tools for maintenance and installation . Drywall (also called plasterboard, dry lining, [1] wallboard, sheet rock, gib board, gypsum board, buster board, turtles board, slap board, custard board, gypsum panel and gyprock) is a panel made of calcium sulfate dihydrate (), with or without additives, typically extruded between thick sheets of ...

  4. Joint compound - Wikipedia

    en.wikipedia.org/wiki/Joint_compound

    Kitchen renovation spackling to cover holes and tape between sheetrock boards Drywall with joint compound applied.. Joint compound (also known as drywall compound, drywall mud, joint cement or mastic) is a white powder of primarily gypsum dust mixed with water to form a paste the consistency of cake frosting, which is spread onto drywall and sanded when dry to create a seamless base for paint ...

  5. USG Corporation - Wikipedia

    en.wikipedia.org/wiki/USG_Corporation

    In 1909, Avery led the USG acquisition of the Sackett Plaster Board Company, [13] inventor of Sackett Board, which was a panel made of multiple layers of plaster and paper. Patented by USG in 1912, a new manufacturing process produced boards with a single layer of plaster and paper that could be joined flush along a wall with a relatively ...

  6. Spackling paste - Wikipedia

    en.wikipedia.org/wiki/Spackling_paste

    Spackling paste is comparable and contrastable with joint compound as both look similar and serve the similar purpose of filling in low spots in walls and ceilings. [3] The chief differences are that spackling paste typically dries faster, shrinks less during drying, and is meant for smaller repairs, and not for a whole room or house.

  7. Plaster veneer - Wikipedia

    en.wikipedia.org/wiki/Plaster_veneer

    Typically, drywall is surfaced using the "mud-and-tape" method, where non-adhesive paper or mesh tape and drywall joint compound ("mud") is used to fill joints, cover nail heads, and repair any flaws. Plaster veneer was developed as a way of taking advantage of the reduced labor of modern drywall, while providing a genuine plaster surface for a ...

  8. Gypsum - Wikipedia

    en.wikipedia.org/wiki/Gypsum

    Gypsum is a soft sulfate mineral composed of calcium sulfate dihydrate, with the chemical formula CaSO 4 ·2H 2 O. [4] It is widely mined and is used as a fertilizer and as the main constituent in many forms of plaster, drywall and blackboard or sidewalk chalk.

  9. Lath and plaster - Wikipedia

    en.wikipedia.org/wiki/Lath_and_plaster

    Lath and plaster largely fell out of favour in the U.K. after the introduction of plasterboard in the 1930s. [2] In Canada and the United States, wood lath and plaster remained in use until the process was replaced by transitional methods followed by drywall (the North American term for plasterboard) in the mid-twentieth century. [citation needed]