Ad
related to: 6.7 cummins overheating problems
Search results
Results from the WOW.Com Content Network
The 5.9 L Cummins, also known as the "12-Valve" Cummins was the first member of the Cummins B-Series to be used in a light truck vehicle. The 6BT used Bosch fuel systems, injector, and VE rotary pump and P7100 inline injection pumps. Some early 6BTs were supplied with CAV rotary pumps instead, before the Bosch system became the sole standard.
The Cummins L-series engine is a straight-six diesel engine designed and produced by Cummins. It displaces 8.9 litres (543.1 cu in ), and began production in 1982 as the L10 at the Jamestown Engine Plant in Jamestown, New York .
The Duramax V8 engine is a family of 6.6-liter diesel V8 engines produced by DMAX, a wholly owned subsidiary of General Motors in Moraine, Ohio.The Duramax block and heads are supplied from reliable vendors of General Motors.
Cummins Inc. is an American multinational corporation that designs, manufactures, and distributes engines, filtration, and power generation products. [2] Cummins also services engines and related equipment, including fuel systems, controls, air handling, filtration, emission control, electrical power generation systems, and trucks.
6.2L fitted to a 1987 HMMWV. The original 6.2 L (379 cu in) diesel V8 was introduced in 1982 for the Chevrolet C/K and was produced until 1993. The 6.2L diesel emerged as a high-fuel-economy alternative to the V8 gasoline engine lineup, and achieved better mileage than Chevrolet's 4.3L V6 gasoline engine of the 1980s, at a time when the market was focused on power rather than efficiency.
It has greater engine power, replacing the 6.5-liter diesel engine with a Cummins 6.7-liter diesel and Allison 6-speed transmission, as well as a stronger suspension, improved brakes, higher ground clearance, and new onboard instrumentation. Fuel capacity is increased from 27 to 40 US gal (100 to 150 L; 22 to 33 imp gal) and the battery and ...
Oil does not degrade significantly just sitting in a cold engine. On the other hand, if a car is driven just for very short distances, the oil will not fully heat up, and it will accumulate contaminants such as water, due to lack of sufficient heat to boil off the water. Oil in this condition, just sitting in an engine, can cause problems.
With early induction and ignition systems the compression ratios had to be kept low. With advances in fuel technology and combustion management, high-performance engines can run reliably at 12:1 ratio. With low octane fuel, a problem would occur as the compression ratio increased as the fuel was igniting due to the rise in temperature that ...
Ad
related to: 6.7 cummins overheating problems