Search results
Results from the WOW.Com Content Network
The Intel MCS-51 (commonly termed 8051) is a single-chip microcontroller (MCU) series developed by Intel in 1980 for use in embedded systems. The architect of the Intel MCS-51 instruction set was John H. Wharton. [1] [2] Intel's original versions were popular in the 1980s and early 1990s, and enhanced binary compatible derivatives remain ...
Below is the full 8086/8088 instruction set of Intel (81 instructions total). [2] These instructions are also available in 32-bit mode, in which they operate on 32-bit registers ( eax , ebx , etc.) and values instead of their 16-bit ( ax , bx , etc.) counterparts.
The FLAGS register is the status register that contains the current state of an x86 CPU.The size and meanings of the flag bits are architecture dependent. It usually reflects the result of arithmetic operations as well as information about restrictions placed on the CPU operation at the current time.
C = A+B needs two instructions. RISC — arithmetic instructions use registers only, so explicit 2-operand load/store instructions are needed: load a,reg1; load b,reg2; add reg1+reg2->reg3; store reg3,c; C = A+B needs four instructions. Unlike 2-operand or 1-operand, this leaves all three values a, b, and c in registers available for further ...
A distinction between an exercise and a mathematical problem was made by Alan H. Schoenfeld: [2] Students must master the relevant subject matter, and exercises are appropriate for that. But if rote exercises are the only kinds of problems that students see in their classes, we are doing the students a grave disservice. He advocated setting ...
An instruction set architecture (ISA) is an abstract model of a computer, also referred to as computer architecture.A realization of an ISA is called an implementation.An ISA permits multiple implementations that may vary in performance, physical size, and monetary cost (among other things); because the ISA serves as the interface between software and hardware.
The operations also include conversion instructions, which can load or store a value from memory in any of the following formats: binary-coded decimal, 32-bit integer, 64-bit integer, 32-bit floating-point, 64-bit floating-point or 80-bit floating-point (upon loading, the value is converted to the currently used floating-point mode). x86 also ...
Registers are normally measured by the number of bits they can hold, for example, an 8-bit register, 32-bit register, 64-bit register, 128-bit register, or more.In some instruction sets, the registers can operate in various modes, breaking down their storage memory into smaller parts (32-bit into four 8-bit ones, for instance) to which multiple data (vector, or one-dimensional array of data ...