Search results
Results from the WOW.Com Content Network
The two primary methods of deformation in metals are slip and twinning. Slip occurs by dislocation glide of either screw or edge dislocations within a slip plane. Slip is by far the most common mechanism. Twinning is less common but readily occurs under some circumstances. Twinning occurs when there are not enough slip systems to accommodate ...
Plasticity in a crystal of pure metal is primarily caused by two modes of deformation in the crystal lattice: slip and twinning. Slip is a shear deformation which moves the atoms through many interatomic distances relative to their initial positions.
Crystal plasticity assumes that any deformation that is applied to a material is accommodated by the process of slip, where dislocation motion occurs on a slip system. Further, Schmid's law is assumed to be a valid, where a given slip system is said to be active when the resolved shear stress along the slip system exceeds the critical resolved ...
In materials science, slip is the large displacement of one part of a crystal relative to another part along crystallographic planes and directions. [1] Slip occurs by the passage of dislocations on close/packed planes, which are planes containing the greatest number of atoms per area and in close-packed directions (most
Sample deformation mechanism map for a hypothetical material. Here there are three main regions: plasticity, power law creep, and diffusional flow. A deformation mechanism map is a way of representing the dominant deformation mechanism in a material loaded under a given set of conditions. The technique is applicable to all crystalline materials ...
Twinning and slip are competitive mechanisms for crystal deformation. Each mechanism is dominant in certain crystal systems and under certain conditions. [23] In fcc metals, slip is almost always dominant because the stress required is far less than twinning stress. [24] Twinning can occur by cooperative displacement of atoms along the face of ...
PSB structure (adopted from [7]). Persistent slip-bands (PSBs) are associated with strain localisation due to fatigue in metals and cracking on the same plane. Transmission electron microscopy (TEM) and three-dimensional discrete dislocation dynamics (DDD [8]) simulation were used to reveal and understand dislocations type and arrangement/patterns to relate it to the sub-surface structure.
In materials science, Schmid's law (also Schmid factor [a]) describes the slip plane and the slip direction of a stressed material, which can resolve the most shear stress. ...