Search results
Results from the WOW.Com Content Network
The following table lists the units of the Jeffersonian decimal system, and their relationship with one another. The values of these units are based on Jefferson's proposal of a foot that was equal in length to one-fifth of a second rod, one fourth of an inch shorter than the foot in use at the time, and approximately equal to 0.298461684 m. [5]
In the United States, the foot was defined as 12 inches, with the inch being defined by the Mendenhall Order of 1893 via 39.37 inches = 1 m (making a US foot exactly 1200 / 3937 meters, approximately 0.304 800 61 m). [29] [30]
By default, the output value is rounded to adjust its precision to match that of the input. An input such as 1234 is interpreted as 1234 ± 0.5, while 1200 is interpreted as 1200 ± 50, and the output value is displayed accordingly, taking into account the scale factor used in the conversion.
A 1:5 architectural scale (inches to feet) would be a 1:60 unitless scale (inches to inches) since there are 60 inches in 5 feet. Typical scales used in the United States are: [ 1 ] full scale, with inches, divided into sixteenths of an inch
The template is intended for conversion of heights specified in either metres or in feet and inches. Template parameters [Edit template data] Parameter Description Type Status Metres m metre metres meter meters The height in metres. Do not use if feet and inches are specified. Number optional Centimetres cm centimetre centimetres centimeter centimeters The height in centimetres. Do not use if ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
The National Institute of Standards and Technology formerly contended that customary area units are defined in terms of the square survey foot, not the square international foot, [17] but from 2023 it states that "although historically defined using the U.S. survey foot, the statute mile can be defined using either definition of the foot, as is ...