Search results
Results from the WOW.Com Content Network
The Westbay casing system is designed to allow the monitoring of multiple discrete levels in a single borehole. The casing comes in two different sizes, the MP38 system (38 mm, 1.5-inch) and MP55 system (55 mm, 2.25-inch). One single string of water-tight Westbay casing sections is installed in the borehole.
Hydrostatic pressure level sensors are submersible or externally mounted pressure sensors suitable for measuring the level of corrosive liquids in deep tanks or water in reservoirs. Typically, fluid level is determined by the pressure at the bottom of the fluid containment (tank or reservoir); the pressure at the bottom, adjusted for the ...
A water level device showing both ends at the same height. A water level (Greek: Aλφαδολάστιχο or (υδροστάθμη) [Alfadolasticho]) is a siphon utilizing two or more parts of the liquid water surface to establish a local horizontal line or plane of reference.
An insulation monitoring device monitors the ungrounded system between an active phase conductor and earth. It is intended to give an alert (light and sound) or disconnect the power supply when the resistance between the two conductors drops below a set value, usually 50 k Ω (sample of IEC standard for medical applications).
The test often reveals problems that occurred during assembly, such as defective components, improper component placement, and insulator defects that may cause inadvertent shorting or grounding to chassis, in turn, compromising electrical circuit quality and product safety.
While in-circuit test is a very powerful tool for testing PCBs, it has these limitations: Parallel components can often only be tested as one component if the components are of the same type (i.e. two resistors); though different components in parallel may be testable using a sequence of different tests - e.g. a DC voltage measurement versus a measurement of AC injection current at a node.
A GCM or ground continuity monitor (also called a ground integrity monitor or ground continuity tester) is an electrical safety device that monitors the impedance to ground of a temporary electrical circuit and can provide indication (or protective trip) in the event impedance rises to an unsafe value. A GCM is either an external testing device ...
A slug test is in contrast to standard aquifer tests, which typically involve pumping a well at a constant flowrate, and monitoring the response of the aquifer in nearby monitoring wells. Often slug tests are performed instead of a constant rate test, because: time constraints (quick results, or results for a large number of wells, are needed),