Search results
Results from the WOW.Com Content Network
A network administrator reserves a range of IP addresses for DHCP, and each DHCP client on the LAN is configured to request an IP address from the DHCP server during network initialization. The request-and-grant process uses a lease concept with a controllable time period, allowing the DHCP server to reclaim and then reallocate IP addresses ...
The simultaneous use of IPv4 addresses of different scope on the same interface, such as configuring link-local addresses as well as globally routable addresses, may lead to confusion and increased complexity. [1]: 1.9 Therefore, hosts search for a DHCP server on the network before assigning link-local addresses.
The Dynamic Host Configuration Protocol version 6 (DHCPv6) is a network protocol for configuring Internet Protocol version 6 (IPv6) hosts with IP addresses, IP prefixes, default route, local segment MTU, and other configuration data required to operate in an IPv6 network.
More commonly addresses are assigned by a DHCP server, often built into common networking hardware like computer hosts or routers. Most IPv4 hosts use link-local addressing only as a last resort when a DHCP server is unavailable. An IPv4 host otherwise uses its DHCP-assigned address for all communications, global or link-local.
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256
Some DHCP implementations attempt to reassign the same IP address to a host, based on its MAC address, each time it joins the network. A network administrator may configure DHCP by allocating specific IP addresses based on MAC address. DHCP is not the only technology used to assign IP addresses dynamically.
The DHCP server then offers the "lease" of an IP address to the client, which the client is free to request or ignore. If the client requests it and the server acknowledges it, then the client is permitted to use that IP address for the "lease time" specified by the server. At some point before the lease expires, the client must re-request the ...
The IP address and host name of the BOOTP server. The IP address of the server that has the boot image, which the client needs to load its operating system. When the client receives this information from the BOOTP server, it configures and initializes its TCP/IP protocol stack, and then connects to the server on which the boot image is shared.