enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   The Phillips/square screw drive, also known as the Quadrex, Pozisquare screw drive, is a combination of the Phillips and Robertson screw drives. While a standard Phillips or Robertson tool can be used, there is also a dedicated tool for it that increases the surface area between the tool and the fastener so it can handle more torque.

3. SAE 316L stainless steel - Wikipedia

   en.wikipedia.org/wiki/SAE_316L_stainless_steel

   SAE 316L grade stainless steel, sometimes referred to as A4 stainless steel or marine grade stainless steel, is the second most common austenitic stainless steel after 304/A2 stainless steel. Its primary alloying constituents after iron , are chromium (between 16–18%), nickel (10–12%) and molybdenum (2–3%), up to 2% manganese , [ 1 ] with ...

4. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   The idea of a hex socket screw drive was probably conceived as early as the 1860s to the 1890s, but such screws were probably not manufactured until around 1910. Rybczynski (2000) describes a flurry of patents for alternative drive types in the 1860s to the 1890s in the U.S., [2] which are confirmed to include internal-wrenching square and triangle types (that is, square and triangular sockets ...

5. Torx - Wikipedia

   en.wikipedia.org/wiki/Torx

   A security Torx L-key and fastener with holes for a safety pin to hinder disassembly with an ordinary Torx key. A Torx T8 screw head on a hard disk drive.. Torx (pronounced / t ɔːr k s /) is a trademark for a type of screw drive characterized by a 6-point star-shaped pattern, developed in 1967 [1] by Camcar Textron.

6. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   The #6-32 UNC screw has a thread pitch of 1/32 in (0.031250 inches (0.7938 mm)).. The #6-32 UNC is a UTS screw specifying a major thread diameter of #6 which is defined as 0.1380 inches (3.51 mm); and 32 tpi (threads per inch) which equates to a thread pitch of 0.031250 inches (0.7938 mm).

7. Set screw - Wikipedia

   en.wikipedia.org/wiki/Set_screw

   Set screws are not always the best way to resist the torque of driven shafts. To reduce the chance of slipping and to increase load capacity, a detent (often called a "flat") may be milled or ground at the part of the shaft where the set screw's point contacts. The detent, however, must be closely aligned with the threaded hole prior to fastening.