enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   For a screw, this is its outside diameter (OD). The major diameter of a nut cannot be directly measured (as it is obstructed by the threads themselves) but it may be tested with go/no-go gauges. The major diameter of external threads is normally smaller than the major diameter of the internal threads, if the threads are designed to fit together.

3. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   In 1913, Woolley and Meredith defined them like Anthony, but gave the following dimensions: hex head cap screws up to and including 7 ⁄ 16 inch (11.1125 mm) have a head that is 3 ⁄ 16 inch (4.7625 mm) larger than the shank diameter; screws greater than 1 ⁄ 2 inch (12.7 mm) in diameter have a head that is 1 ⁄ 4 inch (6.35 mm) larger than ...

4. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The major diameter may be slightly different from the shank diameter, which is the diameter of the unthreaded part of the screw. The diameters are sometimes given approximately in fractions of an inch (e.g. the major diameter of a #6 screw is 0.1380 in, approximately 9 ⁄ 64 in = 0.140625 in). The pitch P is the distance between thread peaks.

5. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A typical lag screw can range in diameter from 4 to 20 mm or #10 to 1.25 in (4.83 to 31.75 mm), and lengths from 16 to 200 mm or 1 ⁄ 4 to 6 in (6.35 to 152.40 mm) or longer, with the coarse threads of a wood-screw or sheet-metal-screw threadform (but larger).

6. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

7. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   A screw thread, often shortened to thread, is a helical structure used to convert between rotational and linear movement or force. A screw thread is an inclined plane wrapped around a cylinder or cone in the form of a helix, with the former being called a straight thread and the latter called a tapered thread.