enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 3 ⁄ 4 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 3 ⁄ 4 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

3. Chimney - Wikipedia

   en.wikipedia.org/wiki/Chimney

   T i = average temperature inside the chimney, K; T e = external air temperature, K. Combining two flows into chimney: A t +A f <A, where A t =7.1 inch 2 is the minimum required flow area from water heater tank and A f =19.6 inch 2 is the minimum flow area from a furnace of a central heating system.

4. Duct (flow) - Wikipedia

   en.wikipedia.org/wiki/Duct_(flow)

   Ducts for air pollution control in a 17000 standard cubic feet per minute regenerative thermal oxidizer (RTO). A round galvanized steel duct connecting to a typical diffuser Fire-resistance rated mechanical shaft with HVAC sheet metal ducting and copper piping, as well as "HOW" (Head-Of-Wall) joint between top of concrete block wall and underside of concrete slab, firestopped with ceramic ...

5. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

6. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   E.g.: API 5L Grade B – now ISO L245 where the number indicates yield strength in MPa; ASME SA106 Grade B (Seamless carbon steel pipe for high temperature service) ASTM A312 (Seamless and welded austenitic stainless steel pipe) ASTM C76 (Concrete Pipe) ASTM D3033/3034 (PVC Pipe) ASTM D2239 (Polyethylene Pipe) ISO 14692 (Petroleum and natural ...

7. Plastic pipework - Wikipedia

   en.wikipedia.org/wiki/Plastic_pipework

   Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.