Search results
Results from the WOW.Com Content Network
Piston valves are one form of valve used to control the flow of steam within a steam engine or locomotive. They control the admission of steam into the cylinders and its subsequent exhausting, enabling a locomotive to move under its own power. The valve consists of two piston heads on a common spindle moving inside a steam chest, which is ...
An expansion valve is a secondary valve within a steam engine. They represent an intermediate step between steam engines with non-expansive working and later valve gears that could provide for expansion by controlling the motion of a single valve. Expansion valves were used for stationary engines and marine engines. [1]
Collects steam at the top of the boiler (well above the water level) so that it can be fed to the engine via the main steam pipe, or dry pipe, and the regulator/throttle valve. [2] [5] [6]: 211–212 [3]: 26 Air pump / Air compressor Westinghouse pump (US+) Powered by steam, it compresses air for operating the train air brake system.
A locomotive's direction of travel and cut-off are set from the cab by using a reversing lever or screw reverser actuating a rod reaching to the valve gear proper. Some larger steam engines employ a power reverse, which is a servo mechanism, usually powered by steam. This makes control of the reversing gear easier for the driver.
In a steam engine, cutoff is the point in the piston stroke at which the inlet valve is closed. On a steam locomotive, the cutoff is controlled by the reversing gear. The point at which the inlet valve closes and stops the entry of steam into the cylinder from the boiler plays a crucial role in the control of a steam engine. Once the valve has ...
The drive shaft whose speed is being sensed is top right Porter governor on a Corliss steam engine. The devices shown are on steam engines. Power is supplied to the governor from the engine's output shaft by a belt or chain connected to the lower belt wheel. The governor is connected to a throttle valve that regulates the flow of working fluid ...
Double-beat poppet valves became widely used during the nineteenth century. Francis Stevens invented the Stevens valve gear, a double beat poppet valve, in 1839. It was used throughout the nineteenth century and in the early years of the 20th, on side-wheel paddle steamer engines, including the grasshopper engine, in the United States. [4]
The Walschaerts valve gear is a type of valve gear used to regulate the flow of steam to the pistons in steam locomotives, invented by Belgian railway engineer Egide Walschaerts in 1844. [ 1 ] [ 2 ] The gear is sometimes named without the final "s", [ a ] since it was incorrectly patented under that name.