Search results
Results from the WOW.Com Content Network
In contrast to a simple light switch, which is a single pole, single throw (SPST) switch, multiway switching uses switches with one or more additional contacts and two or more wires are run between the switches. When the load is controlled from only two points, single pole, double throw (SPDT) switches are used.
The spinnaker pole is rigged to run from the base of the mast, [1] where there is a special fitting for attaching one end of the pole, out to windward over the side of the boat. There, one of the control lines of whichever sail it is to be used with is run through a fitting on the other end of the spinnaker pole. This allows for more precise ...
The ring was attached to a long, thin pole (the whipstaff proper) and this pole connected the tiller to the helmsman one or more decks above it through a pivot point, roll, or rowle, described as "that round piece of wood or iron wherein the whip doth go and is made turn about that it may carry over the whip from side to side with more ease."
The method for tacking of sailing craft differs, depending on whether they are fore-and aft, square-rigged, a windsurfer, a kitesurfer, or a proa.. Fore-and-aft rig – A fore-and-aft rig permits the wind to flow past the sail, as the craft head through the eye of the wind.
For example, a "2-pole" switch has two separate, parallel sets of contacts that open and close in unison via the same mechanism. The number of "throws" is the number of separate wiring path choices other than "open" that the switch can adopt for each pole. A single-throw switch has one pair of contacts that can either be closed or open.
"To stay" is also a verb: to bring the ship's head up to the wind (to point the bow upwind). [2] This is done in order to go about (to tack ; tacking is sometimes also called staying the vessel [ 3 ] ); the bow of the ship turns upwind, then continues turning until the wind comes over the other side.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
When the boat jibes, the spinnaker pole will be moved from one side of the boat to the other, causing the sheet to become the guy and vice versa. A foreguy may also be used to control the height of the spinnaker pole. It is attached either to the end of the pole or to a bridle on the bottom of the pole, and runs through a padeye on the foredeck ...