Search results
Results from the WOW.Com Content Network
Asynchronous Transfer Mode (ATM) is a telecommunications standard defined by the American National Standards Institute and International Telecommunication Union Telecommunication Standardization Sector (ITU-T, formerly CCITT) for digital transmission of multiple types of traffic.
Data communication, including data transmission and data reception, is the transfer of data, transmitted and received over a point-to-point or point-to-multipoint communication channel. Examples of such channels are copper wires , optical fibers , wireless communication using radio spectrum , storage media and computer buses .
A packet-switched network transmits data that is divided into units called packets.A packet comprises a header (which describes the packet) and a payload (the data). The Internet is a packet-switched network, and most of the protocols in this list are designed for its protocol stack, the IP protocol suite.
A data packet consists of the PID followed by 0–1,024 bytes of data payload (up to 1,024 bytes for high-speed devices, up to 64 bytes for full-speed devices, and at most eight bytes for low-speed devices), [12] and a 16-bit CRC. There are two basic forms of data packet, DATA0 and DATA1. A data packet must always be preceded by an address ...
However, unlike TDMA, there are no time slots, and all CDMA radios can be active all the time to deliver up to 14.4 kbit/s data transmission speeds. With the evolution of CDMA to CDMA2000 and 1xRTT, the use of IS-95 CDMA Circuit Switched Data declined in favour of the faster data transmission speeds available with the newer technologies.
The same problem exists in a mobile ad hoc network . IEEE 802.11 uses 802.11 RTS/CTS acknowledgment and handshake packets to partly overcome the hidden node problem. RTS/CTS is not a complete solution and may decrease throughput even further, but adaptive acknowledgements from the base station can help too.
Data cap; Data Cap Integrity Act; Data circuit-terminating equipment; Data dissemination; Data link; Data over signalling; Data Radio Channel; Data-rate units; Data signaling rate; Data-dependent jitter; Datex code; Degree of isochronous distortion; Degree of start-stop distortion; Differential coding; Digital Audio Access Protocol; Digital ...
Connectionless communication, often referred to as CL-mode communication, [1] is a data transmission method used in packet switching networks, using data packets that are frequently called datagrams, in which each data packet is individually addressed and routed based on information carried in each packet, rather than in the setup information of a prearranged, fixed data channel as in ...