Search results
Results from the WOW.Com Content Network
Gear inches is one way of measuring the gear ratio(s) of a bicycle, so that different gears and different bicycles can be compared in a consistent manner. Gear inches is an imperial measure corresponding to the diameter in inches of the drive wheel of a penny-farthing bicycle with equivalent ( direct-drive ) gearing.
The module is the measure of gear tooth size which is normally used for metric system gears. It is similar to the Diametral Pitch (DP), which is commonly used for UK system (inch measure) gears but they differ in the units used and in that they bear a reciprocal relationship. Module is the pitch circle diameter divided by the number of teeth.
{{convert|100|lb|kg}} → 100 pounds (45 kg) The unit-codes should be treated as case-sensitive: {{convert|100|Mm|mm}} → 100 megametres (1.0 × 10 11 mm) The output of {{convert}} can display multiple converted units, if further unit-codes are specified after the second unnamed parameter (without the pipe separator). Typical combination ...
Length; system unit code (other) symbol or abbrev. notes conversion factor/m combinations SI: gigametre: Gm Gm US spelling: gigameter: 1.0 Gm (620,000 mi) megametre: Mm Mm US spelling: megameter: 1.0 Mm (620 mi) kilometre: km km US spelling: kilometer: 1.0 km (0.62 mi) km mi; hectometre: hm hm US spelling: hectometer: 1.0 hm (330 ft) decametre ...
Length; Name of unit Symbol Definition Relation to SI units ångström: Å ≡ 1 × 10 −10 m: ≡ 0.1 nm astronomical unit: au ≡ 149 597 870 700 m ≈ Distance from Earth to Sun ≡ 149 597 870 700 m [1] attometre: am ≡ 1 × 10 −18 m: ≡ 1 × 10 −18 m: barleycorn (H) = 1 ⁄ 3 in (see note above about rounding) = 8.4 6 × 10 −3 m ...
Initially, many people were disappointed because the first TRX450R was very weak compared to the CRF450R. Honda claims that it designed the TRX450R engine to produce more torque so that the engine was more suited for ATV purposes. In 2004 and 2005, the only interchangeable part between the ATV and motorcycle engines was the camshaft.
Meshing of two spur gears with involute external teeth. z 1 = 20, z 2 = 50, α = 20°, x 1 = x 2 = 0, ISO 53:1998. The lower (green) gear is the driving one. The line of contact, which is the locus of all teeth contact points, is shown in blue.
Spur gears or straight-cut gears are the simplest type of gear. They consist of a cylinder or disk with teeth projecting radially. They consist of a cylinder or disk with teeth projecting radially. Viewing the gear at 90 degrees from the shaft length (side on) the tooth faces are straight and aligned parallel to the axis of rotation .