Search results
Results from the WOW.Com Content Network
Speer Gold Dot 124gr 9mm+P in SIG P226 magazines. Overpressure ammunition, commonly designated as +P or +P+ (pronounced Plus-P or Plus-P-Plus), is small arms ammunition that has been loaded to produce a higher internal pressure when fired than is standard for ammunition of its caliber (see internal ballistics), but less than the pressures generated by a proof round.
dm dm US spelling: decimeter: 1.0 dm (3.9 in) centimetre: cm cm US spelling: centimeter: 1.0 cm (0.39 in) cm in; millimetre: mm mm US spelling: millimeter: 1.0 mm (0.039 in) mm in; micrometre: μm (um, micrometre) μm US spelling: micrometer: 1.0 μm (3.9 × 10 −5 in) nanometre: nm nm US spelling: nanometer: 1.0 nm (3.9 × 10 −8 in) non-SI ...
Belt: An ammunition belt is a device used to retain and feed cartridges into some machine guns in place of a magazine. Belted magnum or belt: Any caliber cartridge, generally rifles, using a shell casing with a pronounced "belt" around its base that continues 2 to 4 mm past the extractor groove. [1]
The delta L problem (ΔL problem) refers to certain firearm chambers and the incompatibility of some ammunition made for that chamber. ΔL is a Commission Internationale Permanente (C.I.P.) geometric dimensioning and tolerancing definition for cartridge cases that are longer than the chamber they have to fit in. "Delta L" essentially means "difference in length".
The MIL-STD-1168 is a set of standard codes used to identify munitions (ammunition, explosives and propellants). It was designed to replace the previous confusing Ammunition Identification Code (AIC) system used by the United States Army Ordnance Department.
This article lists firearm cartridges which have a caliber in the 2.00 to 2.99 millimetres (0.079 to 0.118 in) range. All measurements are in mm (in). 2 mm cartridges
The plant being built by defense company Rheinmetall at its existing site in Unterluess in northern Germany is expected eventually to produce around 200,000 artillery shells per year along with ...
Small arms ammunition pressure testing is used to establish standards for maximum average peak pressures of chamberings, as well as determining the safety of particular loads for the purposes of new load development. In metallic cartridges, peak pressure can vary based on propellant used, primers used, charge weight, projectile type, projectile ...