Search results
Results from the WOW.Com Content Network
Variable Cylinder Management (VCM) is Honda's term for its variable displacement technology, which saves fuel by using the i-VTEC system to disable one bank of cylinders during specific driving conditions—for example, highway driving. The second version of VCM (VCM-2) took this a step further, allowing the engine to go from 6 cylinders, down ...
The Odyssey was engineered by Kunimichi Odagaki, then a chief engineer at the Honda's Research and Development Center, along with a team of 20 members [2] — in the wake of Japan's recession of the early 1990s and the possibility of a 25-percent tariffs if the minivans were imported to the U.S. as light trucks. [2]
A Honda K24A Engine with i-VTEC. VTEC (described as Variable Valve Timing & Lift Electronic Control, but stands for Valve Timing Electronically Controlled) is a system developed by Honda to improve the volumetric efficiency of a four-stroke internal combustion engine, resulting in higher performance at high RPM, and lower fuel consumption at low RPM.
1998-2008 3.5 L J35A Debuted in the 1999 Honda Odyssey ... Carburetion Keihin 37.0 mm flat-slide with throttle position sensor (TPS) ? 29hp Honda CRF250X 2-cylinder
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
These use a Chrysler custom Torqueflite 904 automatic transmission with an integral Chevrolet bellhousing. Do not confuse with later AMC 2.5 L engine that uses GM small corporate pattern . Chevrolet Turbo-Thrift engine (post-1962) Chevrolet 153 Inline 4 (Chevy II, pre-Iron-Duke - includes the Vortec 3000/181 industrial/marine crate motor)
The new Odyssey came with the Honda K24A i-VTEC engine, a 2.4-litre unit producing 160 PS (118 kW); this was the same engine used in the CR-V and Accord. A 4WD version (RB2) came only with an automatic transmission, while the 2WD version came only with a continuously variable transmission , except Absolute, JDM S/B model as well as export models.
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.