enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill - Wikipedia

   en.wikipedia.org/wiki/Drill

   The distance from the center of the chuck to the closest edge of the column is the throat. The swing is simply twice the throat, and the swing is how drill presses are classified and sold. Thus, a tool with 4" throat has an 8" swing (it can drill a hole in the center of an 8" work piece), and is called an 8" drill press. [22]

3. Chuck (engineering) - Wikipedia

   en.wikipedia.org/wiki/Chuck_(engineering)

   A pin chuck is a specialized chuck designed to hold small drills (less than 1 mm (0.039 in) in diameter) that could not be held securely in a normal drill chuck. The drill is inserted into the pin chuck and tightened; the pin chuck has a shaft which is then inserted into the larger drill chuck to hold the drill securely. Pin chucks are also ...

4. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   Large drill bits can have straight shanks narrower than the drill diameter so that they can be fitted in chucks not able to chuck the full diameter. Such a drill bit is called a reduced-shank or blacksmith's drill. For example, this allows a 1 ⁄ 2-inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8-inch (9.5 mm) chuck.

5. Hammer drill - Wikipedia

   en.wikipedia.org/wiki/Hammer_drill

   A corded hammer drill next to a drill bit and a chuck key. A hammer drill, also known as a percussion drill or impact drill, is a power tool used chiefly for drilling in hard materials. [1] [2] It is a type of rotary drill with an impact mechanism that generates a hammering motion.

6. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The Jacobs Taper (abbreviated JT) is commonly used to secure drill press chucks to an arbor. The taper angles are not consistent varying from 1.41° per side for No. 0 (and the obscure # 2 + 1 ⁄ 2) to 2.33° per side for No. 2 (and No. 2 short). There are also several sizes between No. 2 and No. 3: No. 2 short, No. 6 and No. 33.

7. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.