enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Patch cable - Wikipedia

   en.wikipedia.org/wiki/Patch_cable

   The patch panel is a flat panel of audio connectors where XLR cables (often both "male" and "female") and 1/4 inch jacks can be plugged in. The "snake" cable makes setup more convenient, because if a sound engineer did not have a "snake", she or he would have to run 20 or 30 individual microphone and instrument cables from the stage to the ...

3. Floppy disk drive interface - Wikipedia

   en.wikipedia.org/wiki/Floppy_disk_drive_interface

   A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a combination. After IBM introduced the "twist" to floppy cables, and when both 5.25-inch and 3.5-inch drives were in common use, many cables had four connectors: one of each type before the twist, and one of each type after the twist.

4. Structured cabling - Wikipedia

   en.wikipedia.org/wiki/Structured_cabling

   Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

5. Patch panel - Wikipedia

   en.wikipedia.org/wiki/Patch_panel

   However, switching equipment that can emulate the capabilities of a given patch bay is much more expensive. For example, an S-Video matrix routing switcher with the same capability (8×8) as a 16-point S-Video patch panel (8 patch cables connects 8 inputs and 8 outputs) may cost ten times more, though it would probably have more capabilities.

6. Networking cable - Wikipedia

   en.wikipedia.org/wiki/Networking_cable

   A patch cable is an electrical or optical cable used to connect one electronic or optical device to another for signal routing. Devices of different types (e.g. a switch connected to a computer, or a switch connected to a router) are connected with patch cables.

7. Power over Ethernet - Wikipedia

   en.wikipedia.org/wiki/Power_over_Ethernet

   The free polarity allows PoE to accommodate crossover cables, patch cables and auto MDI-X. In Mode B, pins 4–5 (pair 1 in both T568A and T568B) form one side of the DC supply and pins 7–8 (pair 4 in both T568A and T568B) provide the return; these are the pairs 10BASE-T and 100BASE-TX do not use.