Search results
Results from the WOW.Com Content Network
Versatility in Connectivity: There is a wide range of sensor inputs and outputs available. Accessibility: The external sensor is easily accessible and can be replaced if necessary without the need for recalibration. Durability: The small sensing bar is positioned along the exterior of the hydraulic cylinder, reducing the risk of environmental ...
This page was last edited on 19 June 2023, at 11:04 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...
The fault could be lack of hydraulic fluid, low brake fluid in the reservoir, a broken hydraulic line or a bad master brake cylinder. The sensor is used to detect pressure differentials in the hydraulic system. If the car alerts a fault in the hydraulic system and the system checks out, the sensor itself may have failed. [2]
Pressure sensors can alternatively be called pressure transducers, pressure transmitters, pressure senders, pressure indicators, piezometers and manometers, among other names. Pressure is an expression of the force required to stop a fluid from expanding, and is usually stated in terms of force per unit area.
A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. [1] Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities (energy, force, torque, light, motion, position, etc.).
For the thin-walled assumption to be valid, the vessel must have a wall thickness of no more than about one-tenth (often cited as Diameter / t > 20) of its radius. [4] This allows for treating the wall as a surface, and subsequently using the Young–Laplace equation for estimating the hoop stress created by an internal pressure on a thin-walled cylindrical pressure vessel:
A piezoelectric sensor is a device that uses the piezoelectric effect to measure changes in pressure, acceleration, temperature, strain, or force by converting them to an electrical charge. The prefix piezo- is Greek for 'press' or 'squeeze'.
The normal output of a VR sensor is an analog signal, shaped much like a sine wave. The frequency and amplitude of the analog signal is proportional to the target's velocity. This waveform needs to be squared up, and flattened off by a comparator like electronic chip to be digitally readable.