Search results
Results from the WOW.Com Content Network
Logs with a higher density than the density of water would sink. [2] Other logs would get caught in jams, sloughs, or floods, and become lodged in the riverbed. Such logs were often known as "sinkers" or "deadheads." Loggers attempted to reduce the number of logs which remained in the river in order to maximize profits, but some losses were ...
There the logs were decked onto "rollways." In spring when snow thawed and water levels rose, the logs were rolled into the river, and the drive commenced. [6] To ensure that logs drifted freely along the river, men called "log drivers" or "river pigs" were needed to guide the logs. The drivers typically divided into two groups.
The log must run in holes containing electrically conductive mud or water, i.e., with enough ions present in the drilling fluid. Indeed, in the borehole fluids the electrical charge carriers are only ions (cations and anions) present in aqueous solution in the fluid. In the absence of dissolved ions, water is a very poor electrical conductor.
A "full deck" of logs awaiting the mill. A log pond is a small natural lake or reservoir used for storage of wooden logs in readiness for milling at a sawmill.Although some mill ponds served this purpose for water-powered sawmills, steam-powered sawmills used log ponds for transportation of logs near the mill; and did not require the elevation drop of watermill reservoirs.
The log-line attaches to the board with a bridle of three lines that connect to the vertex and to the two ends of the quadrant's arc. To ensure the log submerges and orients correctly in the water, the bottom of the log is weighted with lead. [1] This provides more resistance in the water, and a more accurate and repeatable reading.
Spontaneous potential log, commonly called the self potential log or SP log, is a passive measurement taken by oil industry well loggers to characterise rock formation properties. The log works by measuring small electric potentials (measured in millivolts) between depths with in the borehole and a grounded electrode at the surface.
Stoplogs are modular in nature, giving the operator of a gated structure the ability to control the water level in a channel by adding or removing individual stoplogs. A gate may make use of one or more logs. Each log is lowered horizontally into a space or bay between two grooved piers referred to as a stoplog check. [3]
Many relationships between travel time and porosity have been proposed, the most commonly accepted is the Wyllie time-average equation. The equation basically holds that the total travel time recorded on the log is the sum of the time the sonic wave spends travelling the solid part of the rock, called the rock matrix and the time spent travelling through the fluids in the pores.