Search results
Results from the WOW.Com Content Network
A hopper is a large, inverted pyramidal or conical container used in industrial processes to hold particulate matter or flowable material of any sort (e.g. dust, gravel, nuts, or seeds) and dispense these from the bottom when needed. In some specialized applications even small metal or plastic assembly components can be loaded and dispensed by ...
The first use of corona discharge to remove particles from an aerosol was by Hohlfeld in 1824. [2] However, it was not commercialized until almost a century later. In 1907 Frederick Gardner Cottrell, a professor of chemistry at the University of California, Berkeley, applied for a patent on a device for charging particles and then collecting them through electrostatic attraction—the first ...
Dust concentration and particle size – For minerals processing operations, the dust concentration can range from 0.1 to 5.0 grains (0.32 g) of dust per cubic foot of air (0.23 to 11.44 grams per cubic meter), and the particle size can vary from 0.5 to 100 micrometres in diameter.
The route a particle takes will be dependent upon the flow rate of the suspension and the settling rate of the particle and can be seen in the second figure. At the bottom of the vessel a hopper or funnel collects these particles as sludge. Sludge may be continuously or intermittently discharged.
The chemical composition, moisture, acid dew point, and particle loading and size distribution of the gas stream are essential factors as well. Gas temperature – Fabrics are designed to operate within a certain temperature range. Fluctuation outside of these limits, even for a small period of time, can weaken, damage, or ruin the bags.
Economy favors using small tanks; but if flow rate through the tank is too high, most particles will not have sufficient time to settle, and will be carried with the treated water. Considerable attention is focused on reducing water inlet and outlet velocities to minimize turbulence and promote effective settling throughout available tank volume.
Wood chips in a storage hopper, in the middle an agitator to transport the material with a screw conveyor to the boiler. Biomass heating systems generate heat from biomass. The systems may use direct combustion, gasification, combined heat and power (CHP), anaerobic digestion or aerobic digestion to produce heat. Biomass heating may be fully ...
To properly function, a pellet stove uses electricity and can be connected to a standard electrical outlet. A pellet stove, like an automatic coal stoker, is a consistent heater consuming fuel that is fed evenly from a refillable hopper into the burn pot (a perforated cast-iron or steel basin), through a motorized system.