Search results
Results from the WOW.Com Content Network
In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. . Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to t
Electric power is the rate of transfer of electrical energy within a circuit.Its SI unit is the watt, the general unit of power, defined as one joule per second.Standard prefixes apply to watts as with other SI units: thousands, millions and billions of watts are called kilowatts, megawatts and gigawatts respectively.
The unit "var" is allowed by the International System of Units (SI) even though the unit var is representative of a form of power. [9] Per EU directive 80/181/EEC (the "metric directive"), the correct symbol is lower-case "var", [ 1 ] although the spellings "Var" and "VAr" are commonly seen, and "VAR" is widely used throughout the power industry.
Electrical loads consuming alternating current power consume both real power and reactive power. The vector sum of real and reactive power is the complex power, and its magnitude is the apparent power. The presence of reactive power causes the real power to be less than the apparent power, and so, the electric load has a power factor of less ...
In October 1908, at the International Conference on Electric Units and Standards in London, [9] so-called international definitions were established for practical electrical units. [10] Siemens' definition was adopted as the international watt. (Also used: 1 A 2 × 1 Ω.) [5] The watt was defined as equal to 10 7 units of power in the practical ...
The SI unit of work per unit charge is the joule per coulomb, where 1 volt = 1 joule (of work) per 1 coulomb of charge. [citation needed] The old SI definition for volt used power and current; starting in 1990, the quantum Hall and Josephson effect were used, [10] and in 2019 physical constants were given defined values for the definition of all SI units.
The plotted line represents the variation of instantaneous voltage (or current) with respect to time. This cycle repeats with a frequency that depends on the power system. In electrical engineering, three-phase electric power systems have at least three conductors carrying alternating voltages that are offset in time by one-third of the period ...
A schematic representation of long distance electric power transmission. From left to right: G=generator, U=step-up transformer, V=voltage at beginning of transmission line, Pt=power entering transmission line, I=current in wires, R=total resistance in wires, Pw=power lost in transmission line, Pe=power reaching the end of the transmission line, D=step-down transformer, C=consumers.