Search results
Results from the WOW.Com Content Network
The simplest system bus has completely separate input data lines, output data lines, and address lines. To reduce cost, most microcomputers have a bidirectional data bus, re-using the same wires for input and output at different times. [20] Some processors use a dedicated wire for each bit of the address bus, data bus, and the control bus.
In computer architecture, a control bus is part of the system bus and is used by CPUs for communicating with other devices within the computer. While the address bus carries the information about the device with which the CPU is communicating and the data bus carries the actual data being processed, the control bus carries commands from the CPU and returns status signals from the devices.
A system bus is a single computer bus that connects the major components of a computer system, combining the functions of a data bus to carry information, an address bus to determine where it should be sent or read from, and a control bus to determine its operation. The technique was developed to reduce costs and improve modularity, and ...
In other words, this register is used to access data and instructions from memory during the execution phase of instruction. MAR holds the memory location of data that needs to be accessed. When reading from memory, data addressed by MAR is fed into the MDR (memory data register) and then used by the CPU. When writing to memory, the CPU writes ...
Copy data from a memory location or a register to a memory location or a register (a machine instruction is often called move; however, the term is misleading). They are used to store the contents of a register, the contents of another memory location or the result of a computation, or to retrieve stored data to perform a computation on it later.
In a bus mastering system, also known as a first-party DMA system, the CPU and peripherals can each be granted control of the memory bus. Where a peripheral can become a bus master, it can directly write to system memory without the involvement of the CPU, providing memory address and control signals as required.
Along with the control unit it composes the central processing unit (CPU). [1] A larger data path can be made by joining more than one data paths using multiplexers. A data path is the ALU, the set of registers, and the CPU's internal bus(es) that allow data to flow between them. [2] A microarchitecture data path organized around a single bus
Memory-mapped I/O is preferred in IA-32 and x86-64 based architectures because the instructions that perform port-based I/O are limited to one register: EAX, AX, and AL are the only registers that data can be moved into or out of, and either a byte-sized immediate value in the instruction or a value in register DX determines which port is the source or destination port of the transfer.