Search results
Results from the WOW.Com Content Network
An idealized strike-slip fault runs in a straight line with a vertical dip and has only horizontal motion, thus there is no change in topography due to motion of the fault. In reality, as strike-slip faults become large and developed, their behavior changes and becomes more complex. A long strike-slip fault follows a staircase-like trajectory ...
A fault bend, or fault stepover, forms when individual segments of the fault overlap and link together. The type of structures which form along the strike-slip fault depend on the sense of slip relative to the sense of stepping. When a sinistral fault steps to the right or a dextral fault steps to the left, a restraining bend is formed. [2]
Strike-slip faults are commonly almost vertically inclined faults, where the main displacement and slip is in the horizontal direction, parallel to the strike of the fault. Depending on the movement of the fault blocks relative to the fault plane, strike-slip faults can be classified as either sinistral (left-lateral displacement) or dextral ...
Strike-slip faults with left-lateral motion are also known as sinistral faults and those with right-lateral motion as dextral faults. [18] Each is defined by the direction of movement of the ground as would be seen by an observer on the opposite side of the fault. A special class of strike-slip fault is the transform fault when it forms a plate ...
Lateral strike-slip faults. Strike-slip faults occur when the blocks slide against each other laterally, parallel to the plane. The direction of the slip can be observed from either side of the fault, with the far block moving to the left indicating a left lateral slip, and the converse indicating a right lateral slip. See animation here [5]
Transtension is the state in which a rock mass or area of the Earth's crust experiences both extensive and transtensive shear.As such, transtensional regions are characterised by both extensional structures (normal faults, grabens) and wrench structures (strike-slip faults).
Strike-slip faults are associated with dominantly horizontal movement, leading to relatively simple linear zones of surface rupture where the fault is a simple planar structure. However, many strike-slip faults are formed of overlapping segments, leading to complex zones of normal or reverse faulting depending on the nature of the overlap.
Schematic illustration of the two strike-slip fault types. The view is of the Earth's surface from above. In geology, the terms sinistral and dextral refer to the horizontal component of the movement of blocks on either side of a fault or the sense of movement within a shear zone. These are terms of relative direction, as the movement of the ...