Search results
Results from the WOW.Com Content Network
[3] [4] In 1962, Leupold invented the Duplex Reticle, which most riflescopes now use. [6] By 1979, Leupold scopes were generating twice the total revenue of Stevens instruments. [3] [7] In 1969, the company acquired a majority interest in the company Nosler Bullets (also a family company), and then sold off their portion in 1988.
For example, with a typical Leupold brand 16 minute of angle (MOA) duplex reticle (similar to image B) on a fixed-power telescopic sight, the distance from post to post, between the heavier lines of the reticle spanning the center of the sight picture, is approximately 32 inches (810 millimeters) at 200 yards (180 m), or, equivalently ...
The T-mount is a standard lens mount for cameras and other optical assemblies. The usual T-mount is a screw mount using a male 42×0.75 (42 mm diameter, 0.75 mm thread pitch) metric thread on the lens with a flange focal distance of 55 mm and a mating female 42mm thread on a camera adapter or other optical component.
A Leupold telescopic sight mounted on a dovetailed rifle receiver via two scope rings From left: A sketch of a cross section on a Zeiss rail and ring mount, both with a Picatinny rail interface. Scope mounts are rigid implements used to attach (typically) a telescopic sight or other types of optical sights onto a firearm.
NOTE: Some published reviews of 4/3 instead cite the (female) "outside diameter" of the lens or mount as ~50mm (and micro-4/3 as ~44mm), [23] and not the appropriate major diameter (D) ~44mm which is the camera body's female mount inside-diameter and the lens's male mount outside-diameter (micro-4/3 ~38mm).
The Weaver mount was developed by William Ralph Weaver (1905 – 8 November 1975) at his telescopic sight company W.R. Weaver Co., which he founded in 1930. [3] Previous systems included the Leupold/Redfield mounts. [4] Compared to the Leupold mount, the Weaver rail is not as strong and cannot be adjusted for windage. [4]
The B4 mount defines the sensor to have a diagonal size of 11 mm (a so-called 2/3" size sensor). The B4-mount is used by practically all 2/3" broadcast lenses and cameras (as of 2019). Although the standard was set in 1992, the B4 mount already existed before 1980. The Sony BVP-300, produced from 1978, was possibly the first camera with a B4 mount.
It was also noted the mount designed to secure the AN/PVS-4 to the M60 machine gun was difficult to install and prone to loss of zero. The sight reticles for both the M16 rifle and M14 rifle required firing a minimum of 20 rounds to seat before the zeroing procedures could begin, leading to an excessive expenditure of ammunition.