Search results
Results from the WOW.Com Content Network
A parts washer is a piece of equipment used to remove contaminants or debris, such as dirt, grime, carbon, oil, grease, metal chips, cutting fluids, mold release agents, ink, paint, and corrosion from workpieces. Parts washers are used in new manufacturing and remanufacturing processes; they are designed to clean, degrease and dry bulk loads of ...
A pressure washer is used to remove old paint from a boat. Patio flagstones being pressure washed using a rotary nozzle. Pressure washing or power washing is the use of high-pressure water spray to remove loose paint, mold, grime, dust, mud, and dirt from surfaces and objects such as buildings, vehicles and concrete surfaces.
Sprayers range in size from man-portable units (typically backpacks with spray guns) to trailed sprayers that are connected to a tractor, to self-propelled units similar to tractors with boom mounts of 4–30 feet (1.2–9.1 m) up to 60–151 feet (18–46 m) in length depending on engineering design for tractor and land size.
In the late 1960s, spray bottles with trigger-style actuators appeared and quickly became popular, as this design was less fatiguing to use. The original pump-style bottle remained more popular for applications like non-aerosol deodorants, where size was a factor and repeated pumps were not required.
Spray paint being applied to a piece of equipment An LVLP system spray gun. Spray painting is a painting technique in which a device sprays coating material (paint, ink, varnish, etc.) through the air onto a surface. The most common types employ compressed gas—usually air—to atomize and direct the paint particles.
When aerosol paint is used, a stencil can keep the paint constrained to one area. This protects the masked area from being covered in unwanted paint. Stencils can be purchased as movable letters, ordered as professionally cut logos, or hand-cut by artists. Stencils can be used multiple times for recognition and consistency.
Many applications use two-fluid nozzles to achieve a controlled small drop size over a range of operation. Each nozzle has a performance curve, and the liquid and gas flow rates determine the drop size. [5] Excessive drop size can lead to catastrophic equipment failure or may have an adverse effect on the process or product.
The most common causes are accidents with grease guns, paint sprayers, and pressure washers, but working on diesel and gasoline engine fuel injection systems as well as pinhole leaks in pressurized hydraulic lines can also cause this injury. Additionally, there is at least one known case of deliberate self-injection with a grease gun. [2]