Search results
Results from the WOW.Com Content Network
The design of a plain bearing depends on the type of motion the bearing must provide. The three types of motions possible are: Journal (friction, radial or rotary) bearing: This is the most common type of plain bearing; it is simply a shaft rotating in a hole. [3]
S is the Sommerfeld Number or bearing characteristic number r is the shaft radius c is the radial clearance μ is the absolute viscosity of the lubricant N is the speed of the rotating shaft in rev/s P is the load per unit of projected bearing area. The second part of the equation is seen to be the Hersey number.
A ball bearing. A bearing is a machine element that constrains relative motion to only the desired motion and reduces friction between moving parts.The design of the bearing may, for example, provide for free linear movement of the moving part or for free rotation around a fixed axis; or, it may prevent a motion by controlling the vectors of normal forces that bear on the moving parts.
A spherical bearing is a bearing that permits rotation about a central point in two orthogonal directions (usually within a specified angular limit based on the bearing geometry). Typically these bearings support a rotating shaft in the bore of the inner ring that must move not only rotationally, but also at an angle.
Gear bearing cutaway view. A gear bearing is a type of rolling-element bearing similar to epicyclic gearing.Gear bearings consist of a number of smaller 'satellite' gears which revolve around the center of the bearing along a track on the outsides of the internal and satellite gears, and on the inside of the external gear.
NTN Bearing - Malaysia in Selangor, Malaysia, is a producer of ball and roller bearings, drive shafts and other proprietary high-tech automation products. The company has additional branches in Butterworth, Ipoh, Johor Bahru and Kuantan, Malaysia. [14]
The two halves of the bearing are then split at the shim, the shim removed, the oil holes cleared of metal and oil ways are cut into the surface of the new bearing. The shaft is smeared with engineer's blue and rotated in the bearing. When the bearing is disassembled the blue fills the hollows and is rubbed off the high spots, making them visible.
Once the DN factor of a bearing has been obtained, it can be used to consult grease selection charts in order to determine the correct lubricant. Viscosity must be matched to the needs of the bearing in order to obtain maximum efficiency, and to avoid lubricant runout due to overheating, which is a consequence of metal-on-metal contact, as well ...