Search results
Results from the WOW.Com Content Network
Also known as non-hazardous or ordinary locations, these locations are determined to be neither Class I, Division 1 or Division 2; Zone 0, Zone 1 or Zone 2; or any combination thereof. Such areas include a residence or office where the only risk of a release of explosive or flammable gas would be such things as the propellant in an aerosol ...
Maximum experimental safe gap (MESG) is a standardized measurement of how easily a gas flame will pass through a narrow gap bordered by heat-absorbing metal. MESG is used to classify flammable gases for the design and/or selection of electrical equipment in hazardous areas, and flame arrestor devices. [1]
Certified and labelled for use in areas with specific hazardous conditions: for indoor and outdoor use in locations classified as Class II, Groups E, F, or G as defined in NFPA standards such as the NEC. 10: MSHA. Meets the requirements of the Mine Safety and Health Administration, 30 CFR Part 18 (1978). 11: General-purpose.
For example, a mixed shipment of Division 1.2 materials and Division 1.4 materials, both of compatibility group D, must be transported as Division 1.2 materials When Division 1.5 materials, compatibility group D, are transported in the same freight container as Division 1.2 materials, compatibility group D, the shipment must be transported as ...
Class 1: Explosives. Division 1.1: Explosive that has a mass explosion hazard. A mass explosion is a detonation of almost entire load instantaneously. Division 1.2: Goods and Substances without a mass explosion hazard, but with a projection (shrapnel/fragmentation).
The NEC is developed by NFPA's Committee on the National Electrical Code, which consists of twenty code-making panels and a technical correlating committee. Work on the NEC is sponsored by the National Fire Protection Association. The NEC is approved as an American national standard by the American National Standards Institute (ANSI). It is ...
An aerosol must be assigned to Division 2.2 if the contents contain 1% by mass or less flammable components and the heat of combustion is less than 20 kJ/g. Division 2.3 : Toxic Gas Gas poisonous by inhalation means a material which is a gas at 20 °C or less and a pressure of 101.3 kPa (a material which has a boiling point of 20 °C or less at ...
Class IX – Repair parts and components to include kits, assemblies, and subassemblies (repairable or non-repairable) required for maintenance support of all equipment. Class X – Material to support nonmilitary programs such as agriculture and economic development (not included in Classes I through IX).