Ads
related to: 10.9 vs 12.9 bolts compared to 6
Search results
Results from the WOW.Com Content Network
ASTM F568M is an ASTM International standard for metric bolts, screws and studs that are used in general engineering applications. It is titled: Standard Specification for Carbon and Alloy Steel Externally Threaded Metric Fasteners. It defines mechanical properties for fasteners that range from M1.6 to 100 in diameter. The standard was ...
ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...
In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...
High-strength steel parts (such as bolts of strength category > 10.9 and nuts of > 9) and components with tensile strength of > 1000 N/mm 2 or > 320 HV are susceptible to hydrogen embrittlement. Galvanic coating processes and pickling with acids have a major influence on the development of hydrogen-induced brittle fractures.
Mild steel bolts have property class 4.6, which is 400 MPa ultimate strength and 0.6*400=240 MPa yield strength. High-strength steel bolts have property class 8.8, which is 800 MPa ultimate strength and 0.8*800=640 MPa yield strength or above. The same type of screw or bolt can be made in many different grades of material.
M8x1 to M100x4 hexagon head bolts with fine pitch thread – Product grades A and B: Withdrawn: DIN EN ISO 8765, DIN EN ISO 8676: ISO 8765, ISO 8676: DIN 961: M8x1 to M52x3 hexagon head bolts with fine pitch thread – Product grades A and B: Withdrawn: DIN EN ISO 8676: ISO 8676: DIN 962: Designation system for fasteners: Active: DIN 963
With respect to shape, stud bolts a.k.a. studs are categorized into three basic types: "fully threaded stud bolts", "tap-end stud bolts", and "double-end stud bolts". Each of these studs have different application. As name suggests, fully threaded studs have full body coverage with threads for full engagement of the matings nuts or similar ...
The table below shows how the rounds compare. Note that reloading data for 160-grain (10 g) bullets for some of the cartridges is not available. This round was designed with an elastomer tip, so that the .308 designed would be safe for the tubular magazine of lever action rifles.
Ads
related to: 10.9 vs 12.9 bolts compared to 6