enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Carry-lookahead adder - Wikipedia

    en.wikipedia.org/wiki/Carry-lookahead_adder

    Logic gate implementation of a 4-bit carry lookahead adder. A block diagram of a 4-bit carry lookahead adder. For each bit in a binary sequence to be added, the carry-lookahead logic will determine whether that bit pair will generate a carry or propagate a carry. This allows the circuit to "pre-process" the two numbers being added to determine ...

  3. Lookahead carry unit - Wikipedia

    en.wikipedia.org/wiki/Lookahead_carry_unit

    By combining 4 CLAs and an LCU together creates a 16-bit adder. Four of these units can be combined to form a 64-bit adder. An additional (second-level) LCU is needed that accepts the propagate and generate from each LCU and the four carry outputs generated by the second-level LCU are fed into the first-level LCUs.

  4. Kogge–Stone adder - Wikipedia

    en.wikipedia.org/wiki/Kogge–Stone_adder

    An example of a 4-bit Kogge–Stone adder is shown in the diagram. Each vertical stage produces a "propagate" and a "generate" bit, as shown. The culminating generate bits (the carries) are produced in the last stage (vertically), and these bits are XOR'd with the initial propagate after the input (the red boxes) to produce the sum bits. E.g., the first (least-significant) sum bit is ...

  5. Brent–Kung adder - Wikipedia

    en.wikipedia.org/wiki/Brent–Kung_adder

    The Brent–Kung adder is a parallel prefix adder (PPA) form of carry-lookahead adder (CLA). Proposed by Richard Peirce Brent and Hsiang Te Kung in 1982 it introduced higher regularity to the adder structure and has less wiring congestion leading to better performance and less necessary chip area to implement compared to the Kogge–Stone adder (KSA).

  6. Carry-skip adder - Wikipedia

    en.wikipedia.org/wiki/Carry-skip_adder

    Breaking this down into more specific terms, in order to build a 4-bit carry-bypass adder, 6 full adders would be needed. The input buses would be a 4-bit A and a 4-bit B, with a carry-in (CIN) signal. The output would be a 4-bit bus X and a carry-out signal (COUT). The first two full adders would add the first two bits together.

  7. Logic gate - Wikipedia

    en.wikipedia.org/wiki/Logic_gate

    A logic circuit diagram for a 4-bit carry lookahead binary adder design using only the AND, OR, and XOR logic gates. A logic gate is a device that performs a Boolean function, a logical operation performed on one or more binary inputs that produces a single binary output.

  8. Carry-select adder - Wikipedia

    en.wikipedia.org/wiki/Carry-select_adder

    A 16-bit carry-select adder with a uniform block size of 4 can be created with three of these blocks and a 4-bit ripple-carry adder. Since carry-in is known at the beginning of computation, a carry select block is not needed for the first four bits. The delay of this adder will be four full adder delays, plus three MUX delays.

  9. Adder–subtractor - Wikipedia

    en.wikipedia.org/wiki/Adder–subtractor

    A 4-bit ripple-carry adder–subtractor based on a 4-bit adder that performs two's complement on A when D = 1 to yield S = B − A. Having an n-bit adder for A and B, then S = A + B. Then, assume the numbers are in two's complement. Then to perform B − A, two's complement theory says to invert each bit of A with a NOT gate then add one.