Search results
Results from the WOW.Com Content Network
Directional boring, also referred to as horizontal directional drilling (HDD), is a minimal impact trenchless method of installing underground utilities such as pipe, conduit, or cables in a relatively shallow arc or radius along a prescribed underground path using a surface-launched drilling rig. Directional boring offers significant ...
Until the arrival of modern downhole motors and better tools to measure inclination and azimuth of the hole, directional drilling and horizontal drilling was much slower than vertical drilling due to the need to stop regularly and take time-consuming surveys, and due to slower progress in drilling itself (lower rate of penetration).
Push-the-bit tools use pads on the outside of the tool which press against the well bore thereby causing the bit to press on the opposite side causing a direction change. Point-the-bit technologies cause the direction of the bit to change relative to the rest of the tool by bending the main shaft running through it.
The ability to vary the directional tendency of the assembly comes from varying the weight on the bit. A fixed assembly has only one directional tendency. The weight on bit allows you to tune that tendency. The bottom-hole assembly (BHA) can be: slick with no stabilisers; a pendulum bottom-hole assembly for reducing the deviation of a well
Discover the best free online games at AOL.com - Play board, card, casino, puzzle and many more online games while chatting with others in real-time.
Trenchless construction includes such construction methods as tunneling, microtunneling (MTM), horizontal directional drilling (HDD) also known as directional boring, pipe ramming (PR), pipe jacking (PJ), moling, horizontal auger boring (HAB) and other methods for the installation of pipelines and cables below the ground with minimal excavation.
The operator also monitors the surface to ensure it remains undisturbed. As the tool nears the exit point, it is slowed down, and an exit pit is dug to locate both the tool and the bore. As the tool enters the exit pit, the operator chooses to either dig up the tool to retrieve it or reverse it back into the first bore pit for retrieval.
Dads tend to have the most fun hobbies — fishing, golfing, bird watching, and, if you're my father-in-law, storytelling.He tends to be an incredibly fun person to shop for this time of year, but ...