enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bolt circle - Wikipedia

   en.wikipedia.org/wiki/Bolt_circle

   On steering wheels for cars utilizing bolt circles, this usually measures 6×70 mm. [3] Some racing wheels attach to the car via a quick release hub, [4] and this hub then usually has a corresponding bolt circle of 6×70 mm. Example of other less used patterns include: 3×1.75 in (44.45 mm), 5×2.75 in (69.85 mm), 6×74 mm and 6×2.75 in (69.85 mm).

3. Wheel sizing - Wikipedia

   en.wikipedia.org/wiki/Wheel_sizing

   The bolt circle diameter is typically expressed in mm and accompanies the number of bolts in your vehicle's bolt pattern. One example of a common bolt pattern is 5x100 mm. This means there are 5 bolts evenly spaced about a 100 mm bolt circle. The picture to the right is an example of a 5×100 mm bolt pattern on a Subaru BRZ. The wheel has 5 lug ...

4. Crochet hook - Wikipedia

   en.wikipedia.org/wiki/Crochet_hook

   Crochet hooks are currently produced in diameters ranging from 0.35 mm to 25 mm. These diameters are indicated both directly in millimeters and by various numerical or literal gauge systems . Hooks under 2.0 mm are made of steel (for its strength) and are alternately termed steel-, lace- or thread hooks.

5. ISO 5775 - Wikipedia

   en.wikipedia.org/wiki/ISO_5775

   Clincher tires can be mounted on straight-side or crochet-type rims. Crochet-type rims are not the same as hooked-bead rims. Such tires are designated with their nominal section width and their nominal rim diameter, separated by a hyphen (-). Both are measured in millimeters. A typical example of a tire marking according to ISO 5775-1 is:

6. Rug hooking - Wikipedia

   en.wikipedia.org/wiki/Rug_hooking

   Rug canvases range from 3.3 holes per inch (hpi) to 5 hpi. The pattern may be stencilled onto the canvas or worked from a chart similar to a needlepoint pattern. Latch hook yarns may be bought pre-cut (usually 2.5 inch lengths) or in skeins and cut to the desired length. Late 20th century Thunderbird latch hooked rug.

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole should be 1/2" longer than the depth penetration of the screw.