enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   A hole punch, also known as hole puncher, ... The diameter of the holes varies between manufacturers, with typical values being 1 ⁄ 4 to 5 ⁄ 16 inch (6 to 8 mm).

3. Comb binding - Wikipedia

   en.wikipedia.org/wiki/Comb_binding

   To bind a document, the user first punches holes in the paper with a specialized hole punch. Pages must be punched a few at a time with most of these machines. If hard covers are desired, they must be punched as well. In bulk applications, a paper drilling machine may be used. Then the user chooses a spine size that will match the document.

4. Knockout punch - Wikipedia

   en.wikipedia.org/wiki/Knockout_punch

   Chassis punches: assorted sizes round and square Chassis punches: assorted sizes round and square disassembled. In metalworking, a knockout punch, also known as a chassis punch, panel punch, Greenlee punch, or a Q-max, [1] is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die, and screw.

5. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   Usually, the punch and die are close to the same dimensions, creating a sheared edge when they meet. A punch that is significantly smaller than the die can be used to produce an extruded hole where the punch displaces the punched material to the sides, forming a tube perpendicular to the punched sheet. [2] [3]

6. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A center punch is used to mark the center of a point. It is usually used to mark the center of a hole when drilling holes. A drill has the tendency to "wander" if it does not start in a recess. A center punch forms a large enough dimple to "guide" the tip of the drill. The tip of a center punch has an angle between 60 and 90 degrees. [1]

7. Ring binder - Wikipedia

   en.wikipedia.org/wiki/Ring_binder

   A standard 8 + 1 ⁄ 2 by 11 inches (220 mm × 280 mm) sheet of paper has three holes with spacing of 4 + 1 ⁄ 4 inches (110 mm). There is a variant for half-letter size pages (8 + 1 ⁄ 2 by 5 + 1 ⁄ 2 inches or 220 mm × 140 mm), whose three rings are 2 + 3 ⁄ 4 inches (70 mm) apart. "Ledger" size binders hold 11-by-17-inch (28 by 43 cm ...