Search results
Results from the WOW.Com Content Network
In electronics, an immittance Smith chart can be created by overlaying both the impedance and admittance grids, which is useful for cascading series-connected with parallel-connected electric circuits. This allows for the visualization of changes in impedance or admittance in the system caused by components of either the series or parallel circuit.
Practical impedance-matching devices will generally provide best results over a specified frequency band. The concept of impedance matching is widespread in electrical engineering, but is relevant in other applications in which a form of energy, not necessarily electrical, is transferred between a source and a load, such as in acoustics or optics.
The measurement is given in % and a lower number is better. Rumble The measure of the low frequency (many tens of Hz) noise contributed by the turntable of an analogue playback system. It is caused by imperfect bearings, uneven motor windings, vibrations in driving bands in some turntables, room vibrations (e.g., from traffic) that is ...
A high impedance load (e.g. by plugging the end of the line) will cause a reflected wave in which the direction of the pressure wave is reversed but the sign of the pressure remains the same. Since a transmission line behaves like a four terminal model, one cannot really define or measure the impedance of a transmission line component.
The purpose of the middle ear ossicles is to overcome the impedance mismatch between air waves and cochlear waves, by providing impedance matching. Also located in the middle ear are the stapedius muscle and tensor tympani muscle, which protect the hearing mechanism through a stiffening reflex. The stapes transmits sound waves to the inner ear ...
An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).
The middle ear matches mechanical impedance, like a lever. Ordinarily, when sound waves in air strike liquid, most of the energy is reflected off the surface of the liquid. The middle ear allows the impedance matching of sound traveling in air to acoustic waves traveling in a system of fluids and membranes in the inner ear. This system should ...
An acoustic horn or waveguide is a tapered sound guide designed to provide an acoustic impedance match between a sound source and free air. This has the effect of maximizing the efficiency with which sound waves from the particular source are transferred to the air. Conversely, a horn can be used at the receiving end to optimize the transfer of ...