Search results
Results from the WOW.Com Content Network
Tank cap-based humidifiers are more inconvenient to fill than top fill tanks, because the demineralization filter has to be unscrewed and screwed back on a daily basis. Also, water drops from the tank attachment may get in contact with the hygrometer, which will make it harder to operate properly if they are not operated with caution.
The water then falls to the steam scrubber where the slight pressure loss causes the water to flash a little bit which also aids the removal of oxygen and non-condensables. The water then overflows to the storage tank. The gases are then vented to the atmosphere. With vacuum deaeration a vacuum is applied to the system and water is then brought ...
The top has a small outlet, usually hidden beneath a plastic dust cap. Internally there is a large hollow body, normally filled with water, and containing a float valve. The valve must always be installed vertically, usually at the top of a short vertical pipe. If the valve body is filled with water, the float moves upwards and closes the valve.
Flexible suction hose, also known as a suction hose, is a specific type of rigid fire hose used in drafting operations. When using this technique, the fire engine draws water for fire fighting from an unpressurized supply, such as a portable water tank, pool, or other static water source, instead of drawing water from a pressurized water supply, such as a fire hydrant.
For water-cooled engines on aircraft and surface vehicles, waste heat is transferred from a closed loop of water pumped through the engine to the surrounding atmosphere by a radiator. Water has a higher heat capacity than air, and can thus move heat more quickly away from the engine, but a radiator and pumping system add weight, complexity, and ...
Brine draw: Water is directed through a jet pump, which pulls salt water from the brine tank, before the water and brine pass through the resin bed in the normal direction, if co-current, or in the reverse direction, if counter-current. [11] The output of this typically thirty-minute process is discarded through the drain hose.
Condensate polishers are important in systems using the boiling and condensing of water to transport or transform thermal energy.Using technology similar to a water softener, trace amounts of minerals or other contamination are removed from the system before such contamination becomes concentrated enough to cause problems by depositing minerals inside pipes, or within precision-engineered ...
Water is inexpensive, non-toxic, and available over most of the earth's surface.Liquid cooling offers higher thermal conductivity than air cooling. Water has unusually high specific heat capacity among commonly available liquids at room temperature and atmospheric pressure allowing efficient heat transfer over distance with low rates of mass transfer.